Glide Gear TMP 750 User manual

TMP 750
For more informaon please visit our website: www.glidegear.net
Requirements
In order to use the TMP 750, you will need the following items, which are not in-
cluded with the TMP 750:
• A video recording device such as a DSLR or a Mirrorless camera, a tablet
or a smartphone. The TMP 750 does not come with a phone or a tablet
mount/adapter.
• A device, typically, a tablet or a cellphone, displaying the script to be read
in front of the camera. The device will need to be equipped with a tele-
prompng applicaon or soware allowing mirroring of text.
• A tripod capable of supporng the weight of the enre setup.
Compability
• DSLR/Mirrorless Cameras: the distance between the mounng hole at the
boom of the camera and the front of the lens should not exceed 12” or
30cm
• Tablet/Cell phone: the maximum display the TMP 750 will accommodate
without part of the screen not being cut o is 11.5”x 9” or 29cm x 22cm
App Download
Download a free or a paid version of a tele-
prompter in the app store of your tablet or cell-
phone. The app must be able to mirror the script
in order to funcon properly with the TMP 750.

CONTENTS
For more informaon please visit our website: www.glidegear.net
Beam Splier
Tripod Plate
Tablet Clamp
Camera Plate
15mm Rail (long)
15mm Rail
(Short)
Vercal Guiding
Plate (x2) Accessory Clamp
Beam Splier
posioning
clamp
NOTE: The Beam Splier Hood is not displayed in this schemac.

ASSEMBLY
For more informaon please visit our website: www.glidegear.net
1The TMP 750 must be mounted on a tripod.
Remove the cheese plate from the tripod head
and screw it onto one of the 2 mounng holes
at the boom of the Tripod Plate.
2Slide the Long Rails through
the Tripod Plate.
If necessary, use the supplied
Short Rails to increase the
length of the rails.
Lock the rail in place using the
Tripod Plate’s thumb screws.
3Slide the Tablet Clamp onto the Long
Rails.
Make sure the Tripod Plate’s Clamp and
the Tablet Clamp are facing each other.
4Slide the Camera Plate onto the rails on the opposite side
of the Beam Splier.
15mm Rail (Short)
15mm Rail (Long)
Camera Plate

ASSEMBLY
For more informaon please visit our website: www.glidegear.net
5Using the 2 thumb screws on the sides of the Beam Splier, set the an-
gle between the Beam Splier and the Long Rails to a 45-degree angle.
Adjustments
45 Degrees
45 Degrees
Your setup should look like
the gure on the right.
6Mount the camera onto the
Camera Plate.
Adjust Beam
Splier Angle
Adjust Beam
Splier Angle
Secure the Script Device by
locking it in between the Tablet
Clamp and the Tripod Plate
Mount Camera
here
Adjust the posion of the Camera
so that the lens is as close as pos-
sible to the Beam Splier
Adjust the height of
the Camera to align
it with the center of
the Beam Splier
7Secure the Device displaying the
script between the Tablet Clamp
and the Tripod Plate.