GMG 3000 SYSTEM Instruction sheet

COATED METALS GROUP
SYSTEM 3000
INSTALLATION GUIDELINES
RECEIVING AND UNLOADING
Unload panel crates/pallets with appropriately sized equipment to avoid
damage to the panels contained within. Extended reach forklifts may be re-
quired depending on the crate/pallet size. Additional equipment may be
needed if unloading with an overhead crane, or other equipment, in order to
avoid damage to the product. Always use a spreader bar and slings in order
to avoid crushing the crates.
Inspect all crates/pallets for any damage prior to unloading. Report any damage to the freight carrier, docu-
ment the damage on the bill of lading and immediately report the damage to CMG. The receiving party must
make all claims for any damage directly to the freight carrier upon receipt. CMG is not responsible for any
damage after the product leaves the factory. The customer is responsible for filing a freight claim for any
damage directly with the freight carrier within 24 hours of receipt. Failure to do so may result in the loss of
the right to receive corrective action.
After unloading, open each crate and verify that the contents matches the attached packing list. Notify your
CMG representative of any mismatches within 24 hours. Failure to do so may result in the loss of the right to
receive corrective action.
STORAGE AND HANDLING
Store crates/pallets in a clean and dry location, and keep them protected from all outside elements and se-
vere conditions. Avoid storing or carrying panels in a flat orientation. Always store and move panels in a ver-
tical position.
INSTALLATION
Inspect all areas that will receive the panels and ensure that all substrates and underlying requirements are
in place and that all surfaces are acceptable for proper panel installation. Do not begin installation until all
conditions are acceptable.
Reference the approved shop drawings and locate the principal components for panel system alignment,
such as doors, windows, corners, soffits or other items that are critical in determining joint locations. Snap
chalk lines in order to ensure that all installation lines are level and plum, and conform to the layout shown on
the approved shop drawings.

Remove panels from the crate and prepare for installation. Any required field modifications for penetrations,
etc. should be done prior to panel installation. Panel installation is progressive, both vertically and horizontal-
ly. Ensure that all panels are oriented correctly with directional arrows facing the same direction for all mica
and metallic finishes that exhibit coil-coating grain flow and paint directionality. Select a starting location in
accordance with the jobsite conditions outlined above regarding panel joint location.
Please refer to Reynobond Face Fastened Installation Guide (Attached) or visit:
https://www.alcoa.com/aap/north_america/catalog/pdf/specifications/FFS_Installation_Guidelines.pdf
Immediately after installation, remove the protective film from the panels. Panels left with the film attached
and exposed may become difficult to remove. Panels left with partially removed film may become discolored.
CLEANING
General cleaning should consist of a solution of mild detergent and water applied with a soft cloth or sponge.
This solution should immediately be rinsed off of the surface with an adequate rinse of clean water. Washing
the panels from top to bottom will help to minimize streaking. It is recommended that the solution be tested on
a small inconspicuous area before using on a large scale. Never use an abrasive device or cleaner on the
painted finish. Aluminum reacts easily to acid or alkaline and both of these should be avoided. Check the
composition of the cleaning material that you are considering using to ensure that they will not discolor or sof-
ten the coating. Do not use organic based solvents such as MEK (methyl-ethyl-keron) or tri-chrome –
ethylene. Both of these solvents can cause peeling of the coating.
These guidelines are intended to illustrate the general installation procedures and requirements for CMG –
System 3000. Each project may vary and require special procedures or details specific to that project only.
Always refer to project specific details and directions, or contact your CMG representative for assistance.
Revision: 2.25.16
COATED METALS GROUP