Goldmedal Karmel King-Digital User manual

© 2017 Gold Medal Products Co. Part No. 18736
Instruction Manual
10700 Medallion Drive, Cincinnati, Ohio 45241-4807 USA
Karmel King
-
Digital
Export Model No. 2620DX, 2621DX, 2620DTX, 2621DTX

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 2
gmpopcorn.com
SAFETY PRECAUTIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
DANGER
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment
will void the warranty and may cause a dangerous condition. This appliance
is not intended to be operated by means of an external timer or separate
remote-control system. NEVER make alterations to this equipment. Read the
Installation, Operating, and Maintenance Instructions thoroughly before
installing, servicing, or operating this equipment.
014_020416
WARNING
To avoid burns, DO NOT touch the kettle or any heated surface.
DO NOT place or leave objects in contact with heated surfaces.
013_092414
WARNING
ALWAYS wear safety glasses when servicing this equipment.
010_010914
WARNING
No user serviceable parts inside. Refer servicing to qualified service
personnel.
011_051514
WARNING
Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive,
Cincinnati, OH 45241 USA 1-(800)-543-0862
022_060215

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 3
gmpopcorn.com
SAFETY PRECAUTIONS (continued)
WARNING
DO NOT allow direct contact of this equipment by the public when used in
food service locations. Only personnel trained and experienced in the
equipment operation may operate this equipment.
Carefully read all instructions before operation.
012_010914
WARNING
This machine is NOT to be operated by minors.
007_010914
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Note: Improvements are always being made to Gold edal’s equipment. This information
may not be the latest available for your purposes. It is critical that you call Gold edal’s
Technical Service Department at 1-800-543-0862 for any questions about your
machine operations, replacement parts, or any service questions. (Gold edal
Products Co. does not assume any liability for injury due to careless handling and/or
reckless operation of this equipment.) General images may be used in manual for
reference only.

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 4
gmpopcorn.com
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims
should be filed immediately with the transportation company. The warranty does not cover
damage that occurs in transit, or damage caused by abuse, or consequential damage due to the
operation of this machine, since it is beyond our control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this
equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold
edal Products Co., 10700 edallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.
Model Description
The Digital ark 20 Corn Treat Unit has a 20 gallon capacity and is available with either right
hand or left hand dump capability (see below for unit description). For electrical specifications,
refer to the Electrical Requirements section of this manual.
2620DX: Export ark 20 with Digital Heat Control and Right Hand Dump.
2621DX: Export ark 20 with Digital Heat Control and Left Hand Dump.
2620DTX: Export ark 20 with Digital Heat Control, Right Hand Dump, and a Dual Timer.
2621DTX: Export ark 20 with Digital Heat Control, Left Hand Dump, and a Dual Timer.
This appliance is intended to be used in household and similar applications such as staff kitchen
areas in shops, offices and other working environments; farm houses; by clients in hotels, motels,
bed and breakfast or other residential type environments.
Items Included with this Unit
2 Cup
Measure
(PN 62807)
Aluminum Scoop
(PN 2071)
2 included with unit
8 Cup
Measure
(PN 69826)
20 Gallon
Measure
(PN 48886) for
popped corn
Wooden addle
(PN 2093)
Instruction
Manual
Registration
Warranty Card

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 5
gmpopcorn.com
Setup
1. Remove all packaging and tape, and accessories before starting operation.
2. This unit must be properly fastened to a sturdy counter, see illustration below for counter
mounting requirements.
Counter Mounting Requirements
3” Minimum Clearance
Between Kettle and Wall
24” Dia.
4 Holes for
5/16” Dia. Bolts
6
31/64
”
1 63/64”
1
7
3/8”
1
9
3/8
”
2” Dia. X 1/8” Thick
Fender Washer
3/4” Minimum
for Wood or
Wood lastic
roducts
5/16
-
18
Grade 5 Bolt
3/16”
Minimum
Thickness for
Stainless Steel
Over Wood
6” Recommended
Minimum Clearance
Between Wall and
Control Box for
Service.
2
1
”
5/16
-
18
Grade 5 Nut

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 6
gmpopcorn.com
3. Prior to operation, rotate the top paddle from the shipping position into the mixing
position and fix into place with the plunger provided. Pull knurled knob of plunger, to free
plunger from shaft (see illustration below).
Once the paddle is positioned, make sure the plunger is securely set into the holes
provided in the shaft.
4. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of this
manual).
addle Assembly
addles shown in
Correct Mixing osition
lunger
(
Be sure plunger is
securely set into hole in shaft.)
Knurled Knob
of lunger

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 7
gmpopcorn.com
Electrical Requirements
The following power supply must be provided:
2620DX, 2620DTX and 2621DX, 2621DTX: 230/400 V~, 6076 W, 50 Hz
This unit is designed to operate on single phase, 16 A P, 4 wire supply, 230 V~ (2 Hot,
1 Neutral, 1 Ground). All electrical components in this machine are 230 V (motors, heat
elements, lights, etc.) and therefore require “Hot to Neutral” connection (NOT “Hot to Hot”).
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
A certified electrician must furnish sufficient power for proper machine operation and install any
supplied receptacle. We recommend this equipment be on a dedicated and protected circuit.
Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold
edal Products Co.’s recommendation that this machine be plugged directly into a wall outlet. The
use of extension cords is not recommended due to safety concerns, and may cause sacrificed
and/or reduced performance. ake sure cord is located to prevent a trip hazard or unit upset.
Receptacle Wiring Diagram
A certified electrician must supply and install the required wall receptacle for this unit, follow
the I PORTANT instructions shown below.
This unit is designed to operate on single phase, 16 A P, 4 wire supply. All electrical components
in this machine are 230 V. If the receptacle is wired incorrectly, the heat elements/kettle and
other electrical components could be at 400 V potential instead of the needed 230 V, resulting in
excessive temperatures in the heat elements (i.e.: kettle) and possible fire, and/or damage to
electrical components.
3 +N+E IEC 309
(Front View)
3 +N+E IEC 309
(Back View)
Connect to
Blue
(Neutral) Wire
L3
N
Not Used
(
If 5 wires provided,
connect Grey here.)
E-G
L2
L1
Connect to
Black
(Hot) Wire
Connect to
Brown
(Hot) Wire
Connect to
Green/Yellow
(Ground) Wire

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 8
gmpopcorn.com
Before You Plug In Machine
1. ake sure all machine switches are OFF before plugging equipment into receptacle.
2. ake sure wall outlet can accept the grounded plugs (where applicable) on the power
supply cord.
3. The wall outlet must have the proper polarity. If in doubt, have a competent
electrician inspect the outlet and correct if necessary.
4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).
5. Install unit in a level position.
CAUTION
If the supply cord is damaged, it must be replaced by Gold Medal Products Co.,
its service agent or similarly qualified persons in order to avoid a hazard.
039_080614

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 9
gmpopcorn.com
OPERATING INSTRUCTIONS
Controls and Their Functions
HEAT/MOTOR SWITCH
Two position, ON/OFF lighted rocker switch – provides power to the heating elements in
the bottom of the kettle, and powers the agitator motor to turn for 30 seconds of every
minute. The green switch light ON indicates there is power to these features.
Note: It is normal for the motor to stop for 30 seconds of every minute (when the otor
Only Switch is OFF).
MOTOR ONLY SWITCH
Two position, ON/OFF lighted rocker switch – provides power to the agitator motor to
run continuously.
Note: The main function of this switch is for mixing the product/popcorn at the
end of the cooking cycle with the kettle in the tilt position, and it is used for
“cleaning mode”.
CIRCUIT BREAKER
The circuit Breaker protects the otor and Heat Control from an overload condition.
KETTLE DUM HANDLE
The Kettle Dump Handle tilts the kettle from the upright cook position to the mix position
or the dump position. The 2 position bracket holds the handle in the tilted position.
Kettle Dump
Handle
2 osition
Bracket
Control anel View
Heat/Motor
Switch
Motor Only
Switch
Digital Heat
Control
Circuit
Breaker
Hole lug

Karmel King
Digital Model No. 2620DX, 2621DX, 2620DTX, 2621DTX
Page 10
gmpopcorn.com
DIGITAL HEAT CONTROL
The Digital Heat Control adjusts the Set Point Temperature of the unit. The machine comes
from the factory preset to achieve a Product Cook Temperature of 280°F. See Digital Heat
Control Adjustment/Calibration section for adjusting the Product Cook Temperature.
D Models: The sound of the buzzer signals kettle heat shut-off. The buzzer will continue
to sound until the unit is turned off or until the unit temperature falls below set point.
DT Models: Dual Timer units. The pre-alarm sounds the buzzer 40°F before Set Point
Temperature; alerting operator that flavor can be added to the mix (the kettle will
continue to heat the mixture). The second buzzer sounds kettle heat shutoff at a Product
Cook Temperature of 280°F. Each buzzer only sounds for 10-15 seconds.
Buttons/Indicator Light Descriptions
U Button / DOWN Button – adjusts the Set point Temperature UP or DN
when in programming mode.
Access Button – accesses programming mode to change Set Point Temperature, see
Heat Control Adjustment section.
Mode Button – exits programming mode and locks in adjustments, see Digital Heat
Control Adjustment section.
Digital Display – display shows temperature of the kettle; this is not the same as the product
temperature. (Reference the Digital Heat Control Adjustment/Calibration section.)
Heat Indicator Light – light is ON when the unit is heating. See image below for D odel
and DT odel indicator descriptions.
Buzzer Indicator Light – See image below for D odel and DT odel indicator light
description.
Digital Heat Control (D Models)
Heat Indicator Light (D Models)
Light is ON when the unit is heating. It goes
OFF when the buzzer sounds (signaling heat
shut-off).
Buzzer Indicator Light (
D Models
)
Light comes ON when the buzzer
sounds (signaling heat shut-off).
Heat Indicator Light (DT Models)
Light is ON when the unit is heating. It stays
on until the second buzzer
sounds (signaling
heat shut-off).
Buzzer Indicator Light (
D
T
Models
)
Light is ON until the first buzzer sounds
(pre-alarm), and then the light goes OFF.
Dual Timer Control (DT Models)