Good Way AQ-V-3M Manual

AQ-V-3M
High Volume HEPA Filtered
Duct Cleaning Vacuum
Operating and
Maintenance
Instructions
Read before operating.

AQ-V-3M
2
CONTENTS:
IMPORTANT SAFETY INSTRUCTIONS............................................................................................. 3-4
GROUNDING INSTRUCTIONS.............................................................................................................4
SETUP......................................................................................................................................................4
OPERATING INSTRUCTIONS ...............................................................................................................5
MAINTENANCE AND STORAGE .........................................................................................................5
TROUBLESHOOTING........................................................................................................................ 6-7
SPARE PARTS:.........................................................................................................................................8
TECHNICAL DATA: ................................................................................................................................8
Thank you for purchasing this Goodway AQ-V-3M. We appreciate your business
and look forward to serving you in the future. As with all Goodway products, you
can be assured that the nest quality components and workmanship
have gone into this machine.
Please take a few minutes to read the following Operating and Maintenance
Instructions. Please pay particular attention to the safety instructions and exercise
caution when using this machine.
GOODWAY®TECHNOLOGIES CORPORATION
HVAC & FACILITY MAINTENANCE SOLUTIONS
For Sales Call: 1-800-333-7467
For Service Call: 1-800-370-2855

AQ-V-3M 3
WARNING
Important Safety Instructions
1. Read all instructions before using. Keep operating manual and safety
instructions with the product at all times.
2. Always disconnect the power before removing the covers or lters from the
AQ-V-3M.
3. Turn off power before unplugging the power cord. When unplugging the
power cord, grasp the plug-not the cord.
4. Do not roll the machine over the power cord, pull the cord, close the door on
the cord or pull the cord around sharp corners. Keep the cord away from hot
surfaces.
5. Do not use the machine if it has a damaged cord or plug.
6. Other than the 3 lters, there are no user serviceable components in the
Goodway AQ-V-3M. Only trained technicians should attempt to make internal
repairs on this equipment.
7. Never clean or change the lters inside a building.
8. Never expose the unit to rain or excess moisture, store unit indoors in a cool,
dry area. If the machine does not operate properly or has been damaged or
exposed to water, return it to factory for service.
9. Always wear a protective respiratory mask and eye protection, especially when
operating vacuum and changing or cleaning lters.
10. Inspect all AC power plugs to be sure the ground pin is in place. Plug directly
into power outlet, do not use adapters on non-grounded wall plugs.
11. Assure that the HEPA lters are perfectly sealed as any air leakage could be
hazardous. Change the gaskets immediately if there is any air leak.
12. Never connect power to equipment unless all covers and safety shields are in
place. Mechanical and electrical parts could activate and cause injury.
13. Never allow anyone but a properly trained technician to use the equipment or
cleaning products. Do not operate unit when fatigued or under the inuence of
drugs or alcohol.

AQ-V-3M
4
14. Keep operation area clear of all persons. Do not use unit with children in the
immediate area.
15. Check condition of hoses and make sure connections and ttings are secure
before operating unit.
16. Do not use unit with combustible uids or where combustible uids or fumes
may be present.
17. The Goodway AQ-V-3M is designed for US standard 115 volt, 60 Hz AC. Volt.
Always check the specications on the equipment before connecting electrical
power to equipment.
GROUNDING INSTRUCTIONS
This appliance must be grounded. If it should malfunction or breakdown,
grounding provides a path of least resistance for electric current to reduce the risk
of electric shock. This appliance is equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances.
WARNING– Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualied electrician or service person
if you are in doubt as to whether the outlet is properly grounded. Do not modify the
plug provided with the appliance – if it will not t the outlet, have a proper outlet
installed by a qualied electrician.
WARNING– To Reduce The Risk Of Electric Shock – Use indoors only.
WARNING– To Reduce The Risk Of Electric Shock – Do not expose to rain.
Store indoors.
SETUP
Remove the outer box and inspect for damage. Report any damage immediately to
your carrier and Goodway. Any attempt at repairing damages may void warranty.
Inspect all of the packing material for all parts before discarding packaging
material.

AQ-V-3M 5
OPERATING INSTRUCTIONS
Goodway AQ-V-3M duct vacuums are designed to pull loose debris out of the air
system to which they are connected and lter out harmful debris such as pollen,
dust, and mold spores with its 3 stage HEPA lter system.
Following are the steps necessary to operate the AQ-V-3M unit. Refer to the
maintenance section of this manual for the daily and pre-start maintenance check.
To test the AQ-V-3M, be sure all lters are in place and the top is closed and latched
in place, and the switch is in the off position. Connect the 12 gauge x 50 foot power
cord to an outlet. Once the power cord is properly connected, turn on the main
power switch.
Running new, the machine will most likely be running at 15 amps. To prevent
overheating, the AQ-V-3M will need to run between 12-13 amps. To do this, the
hose will need to be connected and the lters will need to have started
collecting dust.
MAINTENANCE AND STORAGE
The Filter Bag:
The lter bag should be cleaned after every duct cleaning job. To clean the lter
bag, remove it from the vacuum, empty the large debris into a proper waste
container, and then blow out the remainder of the debris or wash the lter bag.
Make sure there is no one else in the area if blowing out the remaining dust.
The Biostatic Wrap:
The lter bag should be cleaned after every duct cleaning job. To clean the biostatic
wrap, remove it from the vacuum, empty the large debris into a proper waste
container, and then blow out the remainder of the debris or wash the lter bag.
Make sure there is no one else in the area if blowing out the remaining dust.
The Main Cartridge Filter:
The main cartridge lter should be cleaned after every 2-3 duct cleaning jobs. To
clean the main lter cartridge, remove it from the vacuum, turn it upside down
over a proper waste container, and blow air through it from the inside out. Before
replacing, clean the inside of the housing that holds the lter.

AQ-V-3M
6
Problem Cause Solution
Vacuum is Overheating Not enough restriction • Run the vacuum with a
hose.
• If the vacuum is
connected to a large
duct, the vents should
be sealed off to create
proper restriction.
• Not enough voltage to
motor.
• Filters are too new and
are not creating enough
restriction.
• Not enough airow/
vacuum is blocked
completely.
• Additional extension
cord is not properly
rated. Over 100 ft
requires a 10 gauge
extension cord.
Motor Overheated Thermal Overload Tripped • Wait for the motor to
cool down. The thermal
overload sensor will
reset.
• If the motor has cooled
down and didn’t
automatically reset.
Remove the switch
plate (S02 square drive),
and press the red reset
button on the motor. See
below for images.
TROUBLESHOOTING

AQ-V-3M 7
TO RESET THE THERMAL OVERLOAD, FOLLOW THE
INSTRUCTIONS BELOW:
1. Remove the 6 square drive screws on the front panel.
2. Press the red button located on the front side of the electrical box on the motor.

AQ-V-3M
8
SPARE PARTS:
Voltage 115 V
Amps 13.8A
Lift 6.9” H2O
Flow 3000 CFM
Intake 8”
TECHNICAL DATA:
Filter Bag – Main Cartridge Filter – Biostatic Wrap
(AQ-V-3M-PFB) –(AQ-V-3M-HPF)– (AQ-V-3M-ESF)

AQ-V-3M 9
NOTES

Provides innovative maintenance solutions for a wide variety
of industries including commercial HVAC, food and beverage
processing, power generation and manufacturing.
HVAC & FACILITY MAINTENANCE SOLUTIONS
For Sales Call: 1-800-333-7467
For Service Call: 1-800-370-2855
GOODWAY®TECHNOLOGIES CORPORATION
420 West Avenue, Stamford, CT 06902 USA
Tel: [phone] · Toll-Free Tel: [phone]
Fax: [phone] · Toll-Free Fax: [phone]
Email: [e-mail]
Visit: www.goodway.com
P/N MNL-AQ-V-3M
©Copyright 2019 Goodway Technologies Corp., Stamford, CT USA
Effective date March 08, 2019
Goodway is a Trademark of Crossford International.
Goodway reserves the right to improve products; contact the factory for the latest conguration and uses.