Good Way DV-3-SSH Manual

DV-3-SSH
Industrial Vacuum Cleaner
OPERATING AND MAINTENANCE INSTRUCTIONS
Goodway Technologies Corporation
420 West Avenue
Stamford, CT 06902-6384
Phone [phone]
Toll Free 1-800-333-7467
Fax [phone]
www.goodway.com
Effective date April 1, 2013
©Copyright 2011Goodway Technologies Corp., Stamford, CT USA
Goodway is a registered trademark of Crossford International LLC
Goodway reserves the right to improve products; contact the factory for the latest configuration and uses.

DV-3-SSH 04/01/2013
2
INTRODUCTION
Thank you for purchasing this Goodway vacuum. We appreciate your business
and look forward to serving you in the future. As with all Goodway products, you
can be assured that the finest quality components and workmanship have gone
into this machine.
Please take a few minutes to read the following Operating and Maintenance
Instructions. By carefully following the instructions, you will obtain years of
trouble free service from this product. Please pay particular attention to the
safety instructions and exercise caution when using this machine.
We are here to serve you!
For Sales call
1-800-333-7467
For Service call
1-800-370-2855
Goodway Technologies Corp.

DV-3-SSH 04/01/2013
3
IMPORTANT SAFETY INSTRUCTION
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
WARNING –To reduce the risk of fire, electric shock or injury:
Do not leave appliance when plugged in. Disconnect unit from power when not in use or
before servicing.
WARNING –To reduce the risk of electric shock –Do not use outdoors or on wet surfaces.
Use only as described in this manual. Use only manufacturer’s recommend accessories and
spare parts.
Do not allow to be used as a toy. Close attention is necessary when used by or near
children.
Do not use with a damaged cord or plug. If unit is not working as it should, has been
dropped, damaged, left outdoors, or droped into water, contact Goodway Technologies
Corporation’s Customer Service at [phone].
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around
sharp edges or corners. Do not run appliance over cord. Keep cord away from heated
surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle plug or appliance with wet hands.
Do not put any objects into openings. Do not use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce airflow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving
parts.
Turn off all controls before unplugging.
Use extra careful when cleaning stairs.
Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas
where they may be present.
Connect to a properly grounded outlet only. See grounding instructions.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot
ashes.

DV-3-SSH 04/01/2013
4
Do not use without dust bag and/or filters in place.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded. If it should malfunction or breakdown,
grounding provides a path of least resistance for electric current to reduce the
risk of electric shock. This appliance is equipped with a cord having an
equipment-grounded conductor and grounding plug. The plug must be inserted
into an appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
WARNING: Improper connection of the equipment-grounding conductor can
result in risk of electric shock. Check with a qualified electrician or service person
if you are in doubt as to whether the outlet is properly grounded. Do not modify
the plug provided with the appliance –if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
Some models (see nameplate) are for use on a nominal 120-volt circuit and has a
grounding attachment plug that looks like the plug illustrated in sketch A below.
A temporary adaptor that looks like the adaptor illustrated in sketches B and C
may be used to connect this plug to a two pole receptacle as shown in sketch B if
a properly grounded outlet is not available. The temporary adaptor should be
used only until a properly grounded outlet (sketch A) can be installed by a
qualified electrician. The green colored rigid ear, lug or the like extending from
the adaptor must be connected to a permanent ground such as a properly
grounded outlet box cover. Whenever the adaptor is used, it must be held in
place by a metal screw.
NOTE: In Canada, the use of an adaptor is not permitted by the Canadian
Electrical Code.

DV-3-SSH 04/01/2013
5
SET-UP
1. Remove from packaging and inspect unit. Report any discrepancies to Goodway
Technologies Corporation’s Customer Service at [phone].
2. Position this vacuum cleaner in the area it will be used.
3. Ensure the filter is in place under the vacuum head.
4. Attach the ground wire with alligator clip from the motor assembly to the filter canister.
5. Attach a hose assembly into the manifold on the front of the vacuum cleaner.
6. Insert the plug into an outlet of the proper voltage and current rating. See the vacuum’s
nameplate for its electrical rating.
7. The light will illuminate. If it doesn’t, check the electrical outlet.
OPERATIION
1. Grip one end of the flexible hose.
2. The three motors are controlled by switchs on the motor head. Switch each one on to
start suction. Unit takes a few seconds to get to speed.
3. Note that there is a vacuum gage located next to the the start / stop switches. As the
filter gets dirty the negative pressure value will increase so this gage can be used to
indicate when the filter shaker should be used or the filters need to be replaced.
4. To stop the vacuum cleaner, switch off the motors.
To Empty the Debris Container:
WARNING –As the filter will be dirty, protective eyewear, breathing mask and gloves must be
worn
Before emptying the debris container, make sure the motor is turned off. Turn the two levers
on the side of the vacuum cleaner fully forward. You can now remove the debris container by
rolling it out from underneath the unit. When the container has ben emptied, put it in its initial
point and make sure that it is correctly arranged. Turn the two levers back to their original
position and the container will be automatically locked.

DV-3-SSH 04/01/2013
6
To Change the Filter:
1. Release the container.
2. Unscrew the nuts that holds the filter cage and release the top clamps that block the filter
container (see figure).
3. Remove the vacuum head.
4. Remove the filter container.
5. Take the filter out by loosening the filter clamps.
6. The inverse operation for re-assembly the filter.

DV-3-SSH 04/01/2013
7
TROUBLESHOOTING
Loss of Suction:
1. Make sure unit is plugged into an outlet of the proper voltage/current rating.
2. Check for clogged filters.
3. Check hose and tools for obstructions or holes.
4. Check vacuum intake for clogging.
5. Check that tank is not too full.
6. Check drum for smooth, even top for proper vacuum seal.
7. Check vacuum lid or drum adapter sealing ring.
8. Check drum for holes or leaks.
9. If the motors do not operate, the brushes need replacing. Contact Goodway at (800)333-
7467 for replacements.
SPECIFICATIONS
Specifications
DV-3-SSH
Motor Power:
3 HP (total)
Input Power:
115 V, 18.2 amps, 50/60 Hz AC
Static Water Lift:
81
Air Displacement:
286 CFM
Filtration:
HEPA Filtration
Tank Capacity:
14 gallons stainless steel
Noise Level:
78 dBA
Dimensions:
20½diameter tank x 49high
Weight:
145 lbs

DV-3-SSH 04/01/2013
8
DV-3-SSH Parts List
REF#
Part#
Qty.
Description
1
AR2415
1
Die-cast deflector
2
AR2002
3
Snap fastening
3
AR2058X
1
Filter chamber
4
AR2001
1
Handle
5
AR2003
1
Union seal
6(a)
AR2413
1
Die-cast union
6(b)
AR2417
1
Die-cast union spring
6(c)
AR2418
1
Die-cast union pawl
6(d)
AR2416
1
Die-cast union pawl pin
7
AR2059
1
Container chamber seal
8
AR2060X
1
Container
9
AR2062
4
Castor
10
AR2063
1
Filter shaker lever
11
AR2065
1
Filter shaker flange
12
AR2066
1
Bellows
13
AR2008
1
Filter shaker knob
14
AR3923
1
Push handle
15
AR3509
2
Metallic lever mechanism rotation fulcrum
16
AR3508
2
Metallic aluminum body
17
AR3507
2
Metallic rotation closing washer
18
AR3506
2
8x35 socket countersunk screw for rotation fulcrum
19
AR3505
2
Nylon spacer
20
AR3510
2
Metallic container fastening lever
21
AR3503
1
RH metallic lifting/release rod
22
AR3504
1
LH metallic lifting/release rod
23
AR3165
1
Chromed curve spring
24
AR3115
2
Cable hanger head cover
25
AR3452
1
2-hole cable hanger hook
26
AR3499
2
PLT profile metallic columns
27
AR2363
2
Fastening lever fulcrum
28
AR3513
2
Socket cap screw for slider pawl
29
AR3921
1
Metallic trolley frame
30
AR3922
2
Square under-head screw for metallic trolley castors
31+32
AR4299KIT
2
Wheel axles kit
33
AR4299
2
Wheel
34
AR2005
1
Castor
35
AR2006
1
Castor with brake
36
AR3878
1
Accessory basket
37
AR2480
1
Zig-zag spring
38
AR2481
1
Filter shaker cage lock pin
39
AR2457
1
Filter shaker cage
40
DA-PF-14
1
Filter
41
AR2456
1
14 spoke filter tightener cage
42
AR2018
1
Filter clamp
43
AR2580
1
Filter holder ring
44
2013
1
“u” shaped filter holder seal
NOT SHOWN
DA-AH-HF
1
HEPA FILTER

DV-3-SSH 04/01/2013
9
DV-3-SSH Assembly Drawing

DV-3-SSH 04/01/2013
10
DV-3-SSH Vacuum Head Parts List
Ref #
Part #
Description
Qty Required
1
AR4082
Head Cover
1
2
AR4059
Spacer
1
3
AR4060
Adhesive Silencer
1
4
AR4085
Cooling Ring
3
5
AR4083
Handle
2
6
AR4084
Plastic Adapter
4
7
AR2029
Power Cord
1
8
380-6-P
DV-E2 Plug
1
9
AR2028
Spiral Lead
1
10
AR3372
Strain Relief
1
11
AR4073
Adhesive Silencer
1
12
AR4058
Head Housing
1
13
AR4086
Faceplate
1
15
AR3524
Vacuum Gauge
1
16
AR3517
Green Light
1
17
AR3518
Red Light
1
18
AR4088
On/Off Switch
2 or 3
19
AR4089
DV-E2 spacer insert
1
38
AR2037
Gasket/Spacer
4 or 6
39
AA2784
115-Volt Motor
3
40
AR4071
Silencer Base
1
41
AR2098
Mesh Screen
2 or 3
42
AR4070
Head Base
1
43
AR4097
Fastening Cap
2 or 3

DV-3-SSH 04/01/2013
11
DV-3-SSH Vacuum Head Assembly Drawing

DV-3-SSH 04/01/2013
12
We Are Here to Serve You!
For Sales Call: 1-800-333-7467
For Service Call: 1-800-370-2855
GOODWAY TECHNOLOGIES CORPORATION
420 WEST AVENUE, STAMFORD, CT 06902 USA
Tel: [phone] · Toll-Free Tel: [phone]
Fax: [phone] · Toll-Free Fax: [phone]
[e-mail]
www.goodway.com
Goodway Technologies Corporation
manufactures and distributes a complete line of
Tube/Pipe Cleaning Systems, Duct Cleaning
Systems, Vacuums, Hi-Pressure Washers and other
maintenance related equipment.