BATTERY CHARGING
Attention: Fully recharge the battery before use.
Recharge for at least 24 hours to activate the battery before the first use, after
which the time for a complete recharge is approximately 16 hours.
Do not start the appliance during recharge.
Fully discharge the battery before a new recharge.
• Connect the adaptor (D) to the charging socket (H) and insert the plug of the
adapter (D) into a mains power socket. The LED light on the upper part of the
motor unit will be red and turns green when the appliance is full charge.
Attention: The upper part of the motor unit (B) may warm up during recharge; this
is normal.
Avoid recharging the unit at a temperature below 40°F or above 105°F to prevent
damage to the batteries.
If the appliance does not work, check that it is properly powered on and correctly
plugged in. The appliance will have a longer and better operation when it is used
at certain intervals.
Important: if its functioning seems to be shorter after repeated use, it does not
mean the motor unit is faulty. Such inconvenience may be solved by leaving the
appliance on until it stops working, and then recharging it for approximately 16
hours. This procedure serves to improve the accumulator charging time. Repeat
this operation several times if necessary. If the operating time is still short, contact
the service center.
HOW TO OPERATE
CLEANING AND CARE
WARRANTY DETAILS
This product is guaranteed under
a one
year limited warranty period, applicable to
the original purchaser and not transferable to a third party user.
Repair or replacement of defective parts are at the seller's discretion. In the event
that repair isn't possible, the seller will replace the product/ part. If product repair/
replacement won’t suce, the seller has the option of refunding the cash value of
the product or component returned.
Product defects not covered under the warranty provisions include normal wear
and damage incurred from use or accidental negligence, misuse of instruction
specifications, or repair by unauthorized parties. The manufacturing company is not
liable for any incidental or consequential damages incurred by such circumstances.
8 9
Fig. 5
Fig. 6
Fig. 4
container itself by means of the suitable
clamps (Fig. 6).
• Switch the appliance on by pressing the
apposite ON/OFF button (A).
• Start the operation by means of the
button (G) of the speed “I”. Increase the
speed according to requirements by
pressing the apposite button (G) of the
speed “II” again.
• In case some food remains on the
container sides, switch the appliance o
and move food towards the center, using
an appropriate spatula.
• After the operation, switch the appliance
o by pressing the ON/OFF button (B).
When the battery is low, the appliance
emits a warning.
• Recharge the motor unit (B) by removing
it from the appropriate support (C) and
rotating it clockwise or disassemble the
appliance to clean it.
ATTENTION: Before using the appliance,
make sure all attachments are properly
mounted. To prevent personal injuries and
damages to the appliance, always keep
hands and kitchenware out of moving
parts.
• The shaft (F) and the mixing paddle (E) can be put in the dishwasher or washed by
hand in warm water with mild detergent.
• Use a damp cloth for cleaning the motor unit (B) and the motor support (C).
ATTENTION: After cleaning, allow all parts to dry completely before mounting.