Graco 288359 User manual

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2006, Graco Inc. is registered to I.S. EN ISO 9001
311838A
Instructions Parts
Heated Hose In-Rush
Current Limiter
Retrofit kit for Reactor 380 Vac 3 phase electric proportioners.
Model 288359
Installation
1. Shut down the Reactor unit and relieve all pressure from the system.
2. Disconnect the Reactor unit from the power supply.
3. Locate the heated hose transformer connector circled in FIG. 1 and unplug.
Important Safety Instructions
Read all warnings and instructions in your Reactor
manual. Save those instructions.
FIG. 1
Connector

All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
This manual contains English. MM 311838
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
www.graco.com
12/2006
4. Remove bolts that hold the transformer to the bottom of the unit. See FIG. 2.
5. Place in-rush assembly into case, placing transformer bolts through the rear holes on the in-rush bracket. Tighten
bolts. See FIG. 3.
6. Connect plugs from in-rush limiter to mating plugs disconnected in step 3. See FIG. 3.
7. Route wires over transformer. See FIG. 3.
FIG. 2
FIG. 3
Bolts
Bolts