Graham Field Everest Jennings 300-505L User manual

300-505-INS-LAB-RevB18 1
300-505 / 300-505L POSITIONING BELT, PUSH-BUTTON STYLE:
INSTALLATION AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions
before installing or using the Positioning Belt. If the
Positioning Belt is not properly installed, personal injury and
damage to the Positioning Belt could result.
WARNING: If components are damaged or missing, contact
your GF authorized distributor immediately. DO NOT use
substitute parts. Use only Everest & Jennings replacement
parts. Non-Everest & Jennings replacement parts could cause
personal injury and damage to the Positioning Belt.
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov.
WARNING: GF Health Products, Inc. assumes no responsibility
for any damage or injury caused by improper assembly,
installation or use of this product.
INTENDED USE
This product is intended as a positioning belt only.
WARNING: This product is not intended for use as a transport
safety device.
INSTALLATION (SEE PICTURES AT RIGHT)
To mount the Positioning Belt, loosen and remove the rear seat
upholstery screw on each side. With belt positioned so that buckle is
upward when fastened, slide belt between seat upholstery and seat
rail, centering grommets on screw holes. Replace screws and tighten.
Length Adjustment
Adjust belt length by loosening or tightening the unsecured belt
end on each side of the buckle; both sides of the belt should be of
equal length. The t must be snug, but not so tight that comfort or
breathing is compromised. You should be able to slide your open
hand between the belt and the wheelchair user.
WARNING: Ensure Positioning belt is properly adjusted, and
Positioning Belt and mounting screws are securely installed,
before use.
OPERATION (SEE PICTURES AT RIGHT)
To lock the belt, press the push button and slide the latch into the
buckle until it clicks into place. To unlock the belt, press the push
button and slide the latch out from the buckle.
MAINTENANCE AND CLEANING
WARNING: If signs of wear appear, replace the Positioning
Belt.
WARNING: Check the Positioning Belt mounting screws
monthly and tighten as needed.
sNOTICE: Do not use corrosive cleansers to clean this product.
Clean the Positioning Belt as needed with a mild soap and water
solution.
Positioning Belt
shown unlocked
Mounting Positioning Belt
under rear upholstery screw
300-505 Positioning Belt
300-505L Positioning Belt
Positioning Belt
shown locked
latch
grommet
buckle
push
button
belt
screw
seat
upholstery

300-505-INS-LAB-RevB18 2
1.770.368.4700
Information contained herein is subject to change.
The most current and complete product information can be found on our website.
www.grahameld.com
© 2015, GF Health Products, Inc. All Rights Reserved.
E&J, Everest & Jennings, and Graham-Field are trademarks of GF Health Products, Inc., One Graham-Field Way, Atlanta GA 30340-3140
GF Health Products, Inc. is an ISO 13485 Certied Company.
WARRANTY
SCOPE OF WARRANTY
GF Health Products, Inc. (“GF”) warrants to the original purchaser only that it will replace or repair components, at
GF’s sole discretion, that are defective in material or workmanship under normal use and service. All warranties are
conditioned upon the proper use of the products strictly in accordance with good commercial practice and applicable
GF instructions and manuals, including proper use and maintenance. To the extent that a component is warranted by
a third party, GF conveys all of its rights under that warranty to the original purchaser, to the extent permitted. This
limited warranty shall only apply to defects that are reported to GF’s customer service team within the applicable
warranty period and which, upon examination by GF or its authorized representative, prove to be a warranty item.
This limited warranty is not transferable. Within the guidelines set forth in this document, this product is warranted
for three (3) months. The applicable warranty period shall commence from date of shipment to the original customer,
unless there is an expiration date on the component in which case the warranty shall expire on the earlier of warranty
period or the expiration date.
OBTAINING WARRANTY SERVICE
This limited warranty shall only apply to defects that are reported to the Distributor from whom the Customer
purchased the product within the applicable warranty period. If there is not a Distributor, you must contact
GF directly by calling 1.770.368.4700, sending a fax request to 1.770.368.2386, or by e-mailing a request to
cs@grahameld.com. Specic directions will be provided by the Customer Service Representative. Failure to abide by
the specic directions will result in denial of the warranty claim.
EXCLUSIONS
The warranty does not cover and GF shall not be liable for the following:
1) Defects, damage, or other conditions caused, in whole or in part, by misuse, abuse, negligence, alteration, accident,
freight damage, tampering or failure to seek and obtain repair or replacement in a timely manner;
2) Products which are not installed, used, or properly cleaned and maintained as required in the ofcial manual for the
applicable product;
3) Products considered to be of a non-durable nature including, but not limited to: casters, lters, fuses, gaskets,
lubricants, and charts;
4) Accessories or parts not provided by GF;
5) Charges by anyone for adjustments, repairs, replacement parts, installation or other work performed upon or in
connection with such products which are not expressly authorized in writing, in advance, by GF;
6) Any labor or shipping charges incurred in the replacement part installation or repair;
7) Costs and expenses of regular maintenance and cleaning; and
8) Representations and warranties made by any person or entity other than GF.
ENTIRE WARRANTY, EXCLUSIVE REMEDY AND CONSEQUENTIAL DAMAGES DISCLAIMER
THIS WARRANTY IS GF’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. GF
MAKES NO IMPLIED WARRANTIES OF ANY KIND INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. IF ANY MODEL OR SAMPLE WAS SHOWN TO THE CUSTOMER, SUCH MODEL
OR SAMPLE WAS USED MERELY TO ILLUSTRATE THE GENERAL TYPE AND QUALITY OF THE PRODUCT AND NOT TO
REPRESENT THAT THE PRODUCT WOULD NECESSARILY CONFORM TO THE MODEL OR SAMPLE IN ALL RESPECTS.
THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PARTS. GF SHALL NOT BE LIABLE
FOR AND HEREBY DISCLAIMS ANY DIRECT, SPECIAL, INDIRECT, INCIDENTAL, EXEMPLARY OR CONSEQUENTIAL
DAMAGES, INCLUDING, BUT NOT LIMITED TO: DAMAGES FOR LOSS OF PROFITS OR INCOME, LOSS OF USE,
DOWNTIME, COVER, OR EMPLOYEE OR INDEPENDENT CONTRACTOR WAGES, PAYMENTS AND BENEFITS.
The warranties contained herein contain all the representations and warranties with respect to the subject matter
of this document, and supersede all prior negotiations, agreements and understandings with respect thereto. The
recipient of this document hereby acknowledges and represents that it has not relied on any representation, assertion,
guarantee, warranty, collateral contract or other assurance, except those set out in this document.
For additional information on this product or this warranty, please contact a GF Customer Service Representative.
NOTES:
1) Additional terms and conditions may apply.
2) Freight claims must be notated on the appropriate shipping documents and must be made with immediacy.
International, federal and state regulations govern specic requirements for freight claims. Failure to abide by those
regulations may result in a denial of the freight claim. GF will assist you in ling the freight claim.
3) Claims for any short shipment must be made within three (3) days of the invoice date.