Grandio GRA-LVR User manual

GREENHOU S E S
GRANDIO
GREENHOUSE LOUVER WINDOW
INSTALLATION MANUAL
© 2013 Grandio Greenhouses, Backyard Living Source Inc. All rights reserved
Model GRA-LVR

PARTS NO.
W04
S04
S06
603C
GREENHOUSE
MODELS
ALL MODELS
ALL MODELS
ALL MODELS
ALL MODELS
DESCRIPTION
Clips
M6*14
M6*14
555
QTY
2
6
5
1
PICTURE
LOUVER WINDOW PARTS LIST
1

1.1 Choose the greenhouse panel you
would like to install the louver window
into. If you are just building your green-
house then installation will be fairly
simple.
1.2 Open the louvers on the window and
note that you will want the openers on
the inside of your greenhouse.
1.3 Attach the louver window before
inserting the polycarbonate panel, you
will need to trim the polycarbonate panel
to t into the extrusion properly.
1.4 Prethread the S06-ML01 nut and
screw into the louver window frame.
Insert into the desired location on the
greenhouse wall. Tighten the fasteners
when installed into desired location.
See and .
NOTE: Louver window may be
installed at your discretion on any
wall of your Grandio Greenhouse.
We recommend installing just
above the base of the greenhouse
for the best support.
2

1.5 Prethread the W04 bracket with the
S04/ML01 screws and nuts, attach the
603C to the framework just above the
louver window. Tighten the fasteners
when rmly in place up to the louver
window.
1.6 You will need to cut the polycarbon-
ate panel to t into this section of the
greenhouse. We recommend laying the
polycarbonate panel at on a piece of
cardboard and cutting it using a utility
knife and a straight edge ruler. Be very
careful and measure twice and cut only
once!
1.7 The polycarbonate panel should rest
inside of the 603C extrusion.
3