Gratz Pilates CADILLAC User manual

CADILLAC
Assembly Instructions

step 2 remove traveling pipes
- locate allen key and traveling pipes
- use allen key to unscrew traveling pipes from top canopy
- carefully remove top canopy
- use allen key to unscrew traveling pipes from Cadillac frame
- remove traveling pipes
note: keep pipes somewhere safe incase of relocation
you will need
allen key
How to Assemble Your Cadillac
What Comes in the Box
Cadillac Frame
(4) Traveling Pipes (6” for transit only)
(2) Vertical Pipes and (2) C2. Vertical Pipes
attached to (1) Push Through Bar
Canopy
- D2. (2) Trapeze Slider Tension Knobs
- D3. (4) 3-way Flange
Trapeze Assembly including...
1. Trapeze Bar
2. Trapeze springs
3. (2) Double Hooks
4. (4) Quicklinks
5. (1) 27” Trapeze Strap
Roll Down Bar [including (2) Roll Down
Springs and (4) Double Hooks]
(2) Leg Springs
- (2) 9” Foot Loops and 4 Double Hooks
(2) Arm Springs [4 Double Hooks]
(3) Safety Chains
- (7) Stow Chain
- (6) Quicklinks
- (3) Swivel Hooks
(2) Wooden Handles
(2) 20” Foot Strap
- 2 Double Hooks
Kuna Board (Spread Eagle)
(2) Sheepskin Hanging Loops
90” Webbing Strap
Allen Key
(2) 5/16” Eye Bolts (side)
(2) 3/8” Eye Bolts (rear)
(2) Trapeze Slider Tension Knobs
STEP 1 - Remove Contents from Box
Place the box long side down. Use the scissors
carefully to cut ties. Two Packed bundles should
be in the box with everything listed on the
“What Comes in the Box”
IMPORTANT NOTE: Two people are required to set up your Cadillac.
Gratz Industries is not responsible for any damages to the Cadillac that is caused by improper opening, set up or installation. Please email customercar[email protected] for any inquiries.
A.
B.
C1.
D1.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
O.
P.
Q.
R.
What You Will Need:
2 peopleScissors Adjustable
Wrench
Allen key
(provided)
STEP 2 - Remove the Traveling Pipes
Use the Allen key to unscrew the traveling pipes from
the Cadillac frame (Figure A). Next, use the Allen key to
unscrew hex screws in the traveling pipes from the
Cadillac frame (Figure B). Be sure to hold the travel
pipes while unscrewing, so they don’t fall through.
Then remove the traveling pipes (Figure C).
OPTIONAL EYE BOLTS for
Remove Allen key insert/bolt that is
inside the Cadillac before installing.
*included

step 2 remove traveling pipes
- locate allen key and traveling pipes
- use allen key to unscrew traveling pipes from top canopy
- carefully remove top canopy
- use allen key to unscrew traveling pipes from Cadillac frame
- remove traveling pipes
note: keep pipes somewhere safe incase of relocation
you will need
allen key
STEP 3 - Place the Vertical Pipes and Canopy on Cadillac
Locate the Allen key and 4 vertical pipes. Loosen the screws and insert the 4 vertical pipes into
he flanges on the Cadillac frame (See Figure D). Tighten the screws until the vertical pipes are
firmly secure (See Figure E). Carefully place the canopy on the top of the 4 vertical pipes (See Figure F).
Carefully tighten the screws until the canopy is firmly secure on top of the vertical pipes (See Figure G).
STEP 4 - Prep for Use
Prior to using, make sure all springs are in place to your liking and are properly attached.
IMPORTANT NOTE: Two people are required to set up your Cadillac.
Gratz Industries is not responsible for any damages to the Cadillac that is caused by improper opening, set up or installation. Please email customercar[email protected] for any inquiries.
STEP 5 - How to Position your Trapeze Set
To adjust the Trapeze set, twist
the 2 black knobs until the top
crossbar is loose (Figure H). Then
slide the Trapeze set to the position
of your liking (Figure I). Tighten the
black knobs until the cross bar is
firmly in place (Figure J).
How to Assemble Your Cadillac - pg. 2
13
57
86
4 2
( Figure D )
( Figure E )
( Figure F )
( Figure G )
( Figure H )
( Figure I ) ( Figure J )

Gratz recommends consulting a physician before starting any exercise program. This manual contains important assembly, safety, and
warranty information. Please read carefully before using your new equipment. USER ASSUMES ALL RISKS FOR IMPROPER CARE.
It is impossible to anticipate every potential issue that may arise while using this equipment, so Gratz makes no representation concerning
the safety of this equipment. For inexperienced or first-time users, we recommend this equipment be set up under the supervision of a trained
professional. Contact customer[email protected] or Pilates Pro Maintenance for assistance: [e-mail]
CAUTION Misuse or improper use of this equipment due to failure to read and
comply with all requirements and warnings could result in serious injury.
- USE ONLY PARTS AND ACCESSORIES PROVIDED BY
THE MANUFACTURER. DO NOT USE COMPONENTS
NOT APPROVED BY GRATZ PILATES.
- MAKE CERTAIN THAT THE EQUIPMENT IS OPERATED
ON A LEVEL SURFACE. KEEP AT LEAST 18IN OF SPACE
BETWEEN EQUIPMENT.
- BE SURE THAT ALL PARTS ARE FULLY TIGHTENED
BEFORE BEGINNING ANY EXERCISE.
- INSPECT THAT THE SPRINGS HAVE NO DEFECTS
SUCH AS CRACKS. IMMEDIATELY REQUEST
REPLACEMENT IF YOU SEE ANY DAMAGES.
- CONFIRM THAT NO TEARS ARE PRESENT IN THE VINYL
LEATHER STRAPS OR HANDLES. IMMEDIATELY REQUEST
REPLACEMENT IF NOTICED.
- USERS UNDER 18 SHOULD HAVE ADULT SUPERVISION.
- KEEP ANY LOOSE ITEMS OR CLOTHES CLEAR FROM
MOVING PARTS AT ALL TIME.
- IT IS THE BUYER’S RESPONSIBILITY TO SUPERVISE
OTHER USERS ON THE PROPER CARE AND USE OF THE
EQUIPMENT. GRATZ STRONGLY RECOMMENDS THAT
NEW USERS BE PROPERLY EVALUATED BEFORE USING
GRATZ EQUIPMENT.
WARNING: As with any exercise activity, the use of
equipment involves risk of injury, damage
and/or possibly death.
By choosing to use Gratz equipment, you and/or
your clients/patients/others assume responsibility for
that risk, not the people who sell, distribute and/or
manufacture this equipment.
Visit www.pilates-gratz.com to find complete
warranty, maintenance, and other assembly instructions.
RECOMMENDED USE AND SAFETY