Grizzly G1600 User manual

Specifications
Mounting Bore ..............................1" x 12 TPI LH
Length ...............................................................6"
Diameter ...........................................................4"
Air Inlet Type ...............................Schrader Valve
Maximum Pressure .................................. 10 PSI
Inflation Method .................... Manual Pump Only
Inventory
A. Pneumatic Sanding Drum .......................... 1
B. Sanding Sleeve .......................................... 1
COPYRIGHT © MARCH, 2008 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#JB10532 PRINTED IN TAIWAN
MODEL G1600
PNEUMATIC SANDING
DRUM FOR MODEL G1495
INSTRUCTIONS
Functional Overview
A pneumatic sanding drum mounted to a lathe
allows for easy and smooth sanding of contours
and curves.
The inflatable bladder provides for easy changes
of the replaceable sanding sleeve and also allows
for fine-tuning of the overall flexibility of the drum
for sanding compound curves and contoured sur-
faces.
By increasing the pressure in the drum, a user
can create a more rigid surface for sanding shal-
low contours. Similarly, by decreasing the pres-
sure, a user can soften the surface of the drum,
allowing it to "wrap-around" workpieces with
tighter curves.
Completely releasing the pressure decreases the
diameter of the drum so the sanding sleeve can
be removed and replaced.
EYE INJURY HAZARD!
Always wear safety glasses
during use to prevent
serious personal injury.
10 PSI MAX
AIR PRESSURE!
Exceeding this PSI may
result in injury/tool damage.
RESPIRATORY HAZARD!
Sanding produces fine
dust. Wear the appropriate
protection during use!
Figure 1. Model G1600.
A
B
Replacement Sanding Sleeves
G4387 4" x 6" x 60 Grit Silicon Carbide
G4388 4" x 6" x 80 Grit Silicon Carbide
G1975 4" x 6" x 100 Grit Silicon Carbide
G4389 4" x 6" x 120 Grit Silicon Carbide
G1976 4" x 6" x 150 Grit Silicon Carbide

-2- G1600 Pneumatic Sanding Drum For G1495
Operation
1. DISCONNECT LATHE FROM POWER!
2. Install the sanding drum on the lathe spindle
using the adapter included with the lathe
(Figure 2).
3. Slide the sanding sleeve over the sanding
drum.
4. Use a bicycle pump (or other manual pump)
to inflate the drum until the sanding sleeve is
secure. Do not exceed the 10 PSI maximum
rating.
Figure 2. Mounting drum to shaft.
Operation Tips
• Adjust the pressure in the drum to fine-tune
the firmness of the drum for sanding con-
tours.
• Always hold the workpiece firmly—the soft
surface of the drum will exert more force
on the workpiece than a traditional sanding
drum.
• Deflate the drum when not in use.
Adapter
Sanding Drum
Lathe Outboard
Spindle
Parts Breakdown & List
REF PART # DESCRIPTION
2 P1600002 RUBBER DRUM 4"
3 P1600003 VALVE STEM
4 PWS002 WOOD SCREW #10 X 1/2
5 P1970004 10 PSI MAX. LABEL
6 P1970005 AIR COMPRESSOR LABEL
If you need help with your new pneumatic tool,
call our Tech Support at: [phone].
EXPLOSION HAZARD!
Do not use an air compressor
to inflate the sanding drum!
Over-inflation will cause the
bladder to explode, resulting
in personal injury or tool
damage
2
5
3
4
6