Havis-Shields Pentax Printer Mount '96-08 Ford Crown Victoria... Configuration guide

INSTALL INSTRUCTIONS C-3610-CV
PENTAX PRINTER MOUNT ‘96-08 FORD CROWN VICTORIA
TOOLS REQUIRED:
Power Drill
Drill Bit Set
Phillips Screwdriver
Wire Crimping Tool
HARDWARE:
QTY DESCRIPTION PART
3 #10 X ½” Sheet met l screw GSM33194
3 #10 X ¾” Sheet met l screw GSM33195
5 #8 X 3/8” Bl ck torx screw CM86508
1 #10 X ½” M chine screw GSM33118
REMOVE:
1. Using Phillips screw driver, remove existing inner pl stic glove box ssembly.
(Do not remove glove box door)
INSTALLATION:
1. Subassembly:
• Position printer housing inside glove box
opening on left side. (Approxim tely 1”
inch from side)
• Using the housing hinge s templ te,
m rk the three mounting holes.
• The hinge rod should be bove the glove
box f me. This is critic l to llow the
glove box door to close.
• Drill (3) 9/64” holes
2. Glove box filler:
• The 2000 nd newer model ye rs
requires glove box door filler (CM93605).
• Att ch this filler with (5) #8 X 3/8” Bl ck torx screws.
• On vehicle model ye rs 1996-1999 – remove glove box retr ctor.
Note: 1999 and older models do not get this filler.
3. Mount Printer Housing:
Note: Printer should Not be in the housing yet.
• Mount housing ssembly using (3) #10 x ¾” sheet met l screws.
(These screws go through the hinge nd the holes you drilled in sub ssembly)
Housing Hinge Loc tion

C-3610-CV_INST_1-07
• Pl ce l tch “L” br cket on the glove box
door – m rk nd drill 5/32” pilot hole.
(“L” br cket is tt ched to slide r il nd c n be
ccessed through opening in housing) Mount
br cket using (1) #10 X ½” Sheet met l screw.
Check nd djust slide r il bolt s needed.
4. Pentax Printer:
• Put printer into housing.
• Plug in the power nd d t c ble to printer.
• Run d t c ble to Monitor or CPU.
(Depending on pplic tion)
• Run power nd ground to
12volt b ttery or ignition source.
Note: Be sure to fuse appropriately.
5. Glove box lanyard:
• Mount glove box l ny rd
(CM93606) to the glove box
door. (see note)
• Open the glove box so the printer
slide is pproxim tely 95% open.
• Connect other end of l ny rd to
the doorfr me with #10 X ½”
Sheet met l screw.
Note: 2000 and newer is attached to Glo e Box filler with Machine Screw and 1999 and older is
attached to glo e box door with Sheet metal screw.
Mounting on glove box door
Glove box l ny rd
(CM93606)
Glove box door filler
(CM93605)