Hayman Reese 01967 User manual

FOR TOWING PURPOSES ONLY
For towing capacity details please refer to
vehicle owner’s manual or to the
manufacturer. Overloading can void your
warranties.
INSTALLATION INSTRUCTIONS
1967 -TO SUIT MAZDA 6 WAGON AUGUST 2002-ON
PLEASE READ INSTRUCTIONS THROUGH BEFORE YOU BEGIN
WARNING : 1. Do not drill, cut weld or otherwise modify the towbar.
2. If you are using electric welding on a motor vehicle,always check that the vehicle is not equipped with electronic
engine or instrument management equipment. Failure to do so could destroy any onboard computers. If in doubt,
check with the vehicle's manufacturer.
1. Ensure all hardware items have been included.
2. Remove spare wheel.
3. Remove mud flaps where fitted.
4. Remove tail light lenses from rear guards.
5. Remove bumper bar.
6. Remove 1 self tapper & 1 plastic trim button each side from behind tail light housing.
7. Remove 6 plastic trim buttons from lower lip of bumper.
8. Remove1selftapper eachsidefrom toplipof bumperandwheel archthenremove bumper.
9. Remove and discard impact beam.
10.Fit towbar so as to align with impact beam captivenuts, fit6M8boltsspring & flat washers
supplied.
11.Tighten all bolts to torque listing.
12.Usingholes in tail sectionoftowbar as a guidedrill 12.5mm holes throughsparewheel well.
13.Fit boot plate assembly M12 flat & spring washers tighten all bolts to torque listing.
14.Using sticker template as a guide cut bumper as per diagram.
15.Refit in reverse steps 8 to 2.
16.Towbar rating sticker to be conspicuously located on inside rear end of the driver’s door.
(see diagram below)
RECOMMENDED ASSEMBLY TORQUE LISTING
Diameter Grade 8.8 Bolt
Nm
M6 9.5
M8 21.7
M10 43.4
M12 77.3
M16 189.8
MAX TOW WEIGHT
1000kg
MAX BALL LOAD 80kg

1967 -TO SUIT MAZDA 6 WAGON AUGUST 2002-ON
PLEASE NOTE: You must remove the lug unless you are actually towing if it obscures your number plate. Failure to do
so may result in a fine.