Herman Miller Celle User manual

HermanMiller Celle®Chair Adjustment Guide1
HermanMiller
Celle®Chair
To raise:
Take your weight o chair, li lever up.
To lower:
Li lever up while seated.
At the proper height, your feet should rest flat on the floor.
Seat Height: Lever under right side of seat
To adjust:
While taking your weight o chair, li
lever and adjust seat pan forward or
back. Release lever to lock in position.
In the proper position, you will have approximately three-ngers of clearance
between the back of your knees and the seat edge.
Seat Depth: Lever under le side of seat
Only available on some models.
To increase:
Turn knob clockwise.
To decrease:
Turn knob counterclockwise.
Set the tilt tension to control the resistance you feel when reclining.
Harmonic™Tilt Tension: Knob below front center of seat
Forward Tilt: Horizontal tab under le front side of seat
Only available on some models.
To position chair forward
Recline and flip tab down.
To resume horizontal position:
Recline and flip tab up.
Engage forward tilt to support the thighs’ declined posture when performing
intensive tasks such as keyboarding.

Adjustment Guide2HermanMiller Celle®Chair
Tilt Limiter: Vertical tab under le front side of seat
Only available on some models.
To engage:
Recline and move tab up to dene the
limit of recline.
To release:
Lean forward and press tab back.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
Lumbar Height: Side edges of lumbar support
Only available on some models.
To adjust:
While seated, grasp side edges of
lumbar support, slide lumbar support
up or down to desired height.
Adjust the lumbar height so that it comfortably supports the natural curve
of your spine.
Lumbar Depth: Knob in center of lumbar support
To increase:
While seated, turn knob clockwise.
To decrease:
While seated, turn knob
counterclockwise.
Adjust the lumbar depth so that it comfortably supports the natural curve
of your spine.
Only available on some models.
Arm Height: Outside lever on top of arm support
Only available on some models.
To adjust:
Raise lever to unlock arm, adjust arm,
release lever to lock.
For maximum comfort, your arms should make contact with the arm pad
without any lift at your shoulders.
Arm Angle & Width: Front & rear of each armpad
Only available on some models.
To adjust arm angle:
Grasp front end of armpad and pivot
it inward or outward.
To adjust arm width:
Grasp rear portion of armpad and
adjust arm in or out.
Adjust arm angle inward when using a keyboard; adjust arm angle outward
when using a mouse.
In the proper position, your elbows should be in line with your shoulders.
To adjust footring height:
Hold base with one hand,
grasp footring spoke and turn
counterclockwise (-) to loosen.
Once loose, raise or lower footring
to desired height.
Hold collar with one hand, grasp
footring and turn clockwise (+) to
tighten. To secure, nish turning
footring while holding base.
Footring Height:
Only available on some models.