MAINTENANCE
Ball-Bearing Slides
Note: Unload drawer prior to drawer removal.
Never overload drawers.
To remove drawers and slides, pull drawer all the way out, depress the
black drawer release levers on each slide. For ball-bearing glides, there
is one black lever per slide. One black lever will be pushed down and the
other will be pushed up for drawer removal. After levers are pushed, the
drawer is released. Pull out drawer all the way for removal.
To re-install the drawer, insert guides on drawer side into slides and
fi rmly close drawer all the way.
To maintain the smooth and quiet operation of the ball-bearing slides,
lubricate the extension track that houses the ball bearings every 3-6
months with a high quality jelly-like petroleum based lubricant.
Powder Coat Finish
For heavy build-up of dirt and grime, our powder coat paint fi nish can
be cleaned with WD-40 or Murphy’s Oil Soap using a soft cloth when
needed.
Window cleaner and a soft cloth dampened with water can be used to
clean the fi nish on a regular basis.
Customer Satisfaction
All mechanical parts are inspected and adjusted for proper use before
shipment; however, mechanisms such as drawer slides and locks
may shift during transit.
LEFT DRAWER RELEASE
LEFT DRAWER RELEASE
RIGHT DRAWER RELEASE
RIGHT DRAWER RELEASE
Learn more about tool chests and cabinets we have.
