Home Styles 88 5560 32 User manual

Part List
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
88 5560 32
Dining Table
Tools required for assembly : Slotted screwdriver Tools recommended for assembly : Level
Key Wrench
1 Pc.
M8x40
Bolt
4 Pcs.(+1 extra)
Flat Washer
12 Pcs.(+1 extra)
Nut
12 Pcs.(+1 extra)
Nut Cap
12 Pcs.(+1 extra)
Cover
1 Pc.
Spring Washer
12 Pcs.(+1 extra)
A.
To p
1 Pc.
B.
Leg
4 Pcs.
C.
Side Frame
4 Pcs.
IMPORTANT NOTE
This product is made of sturdy, high quality aluminum
and will provide years of enjoyment. Do not use power tools
to assemble and only tighten bolts until they are snug.
Over tightening can cause damage to the aluminum.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this product and
request that you carefully and strictly follow our assembly
instructions to ensure a completed product as it was designed.

Assembly Instructions 2
STEP 1
Attach Legs (B) to Side Frames (C) with
Flat Washers, Spring Washers, Nuts and
Nut Caps. (See Figure 1 and Figure 2)
Place Top (A) upside down on a soft cloth.
STEP 2
Insert Bolts into the pre-drilled holes of Top (A).
(See Figure 3)
Attach unit to Top (A) with
Flat Washers,
Spring Washers,
Nuts and Nut Caps.
Turn the unit over to its’ upright position.
STEP 3
Cover the umbrella hole with Cover.
To level the unit, adjust the adjustable
levelers on the bottom of legs.
(See Figure 4)
C
C
A
C
C
B
B
B
B
Figure 1 Figure 2
Figure 3
Figure 4
Flat Washer
Flat Washer
Spring Washer
Spring Washer
Nut
Nut
Nut Cap
Nut Cap
Bolt
Cover
/2
IMPORTANT
* Please keep Key Wrench in a safe place as you may need to tighten up the Nuts in the future.
* Use a soft cloth between these parts and the f oor.
* Do not use power tools to assembly and do not overtighten the bolts and nuts.
* Do not tighten up all the bolts and nuts until each part is properly assembled.
* After assembly item must be level to work properly. Use the included adjustable levelers to level.