HON 105 FULL LENGTH PEDESTAL User manual

105 FULL LENGTH PEDESTAL
Sharp edges may cause injury. Take care
when handling metal parts.
To prevent the possibility of serious eye
injury, always wear eye protection when
using power tools.
Read all instructions and review illustrations
before installing.
Tools required for assembly:
1/4" power nutdriver Drill
Flat blade screwdriver Safety glasses
This assembly includes:
(1) Full size pedestal (4) Leveler
(2) Spacer block
Illustration 1
Illustration 2
INSTALLATION IINSTRUCTIONS
Installation:
1. Use two or more people to position desk in loca-
tion where it will be used. Level desk, left-to-
right and front-to-back, by adjusting leveling
glides along bottom edge of desk end panels. If
installing pedestal onto side of desk that has
return mounting screws installed (screws along
front edge of desk), use the 1/4" power nutdriver
to remove screws. Save screws for later use.
2. Refer to Illustration 1. After unloading, remove
drawers from pedestal. Open drawers com-
pletely and locate plastic tabs on side of each
ball bearing slide suspension. Press firmly on
plastic tabs and slide drawers free of pedestal.
3. Refer to Illustration 2. Use the 1/4" power nut-
driver to remove two screws securing lock
bracket to pedestal wall. Save screws and lock
bracket for later use.
4. Place pedestal upside down on cardboard or a
carpeted surface.
5. Refer to Illustration 3. Locate inserts in pedestal
bottom. Thread four levelers (from hardware
pack) into inserts by turning levelers clockwise
until levelers are flat against bottom of pedestal.
6. If installing a row of pedestals under desk, refer
to Access Strip Installation Instructions (pack-
aged with access strip) and install access strip
at this time.
7. Set pedestal upright.
242-7223A
SIDE 1 OF 2 (4/01)
Illustration 3
Drawer
Plastic tab
Pedestal
Pedestal
Lock bracket
Screws
Leveler
Insert Bottom of
pedestal
WARNING

105 FULL LENGTH PEDESTAL
Illustration 4
242-7223A
SIDE 2 OF 2 (4/01)
Spacer
block
Back of
pedestal
Illustration 5
Leveler
Pedestal
Desk end
panel
Skirt
8. Refer to Illustration 4. On spacer blocks, remove pro-
tective backing from mounting tape. At approximately
3" from each side of pedestal and 5" from top edge of
pedestal back, press mounting tape side of spacer
blocks against pedestal back.
9. Refer to Illustration 5. Position pedestal, at desired
location, under desk. Slide pedestal under desk until
pedestal (or spacer blocks) is flat against desk skirt.
Place the cardboard spacer between hanging pedestal
and desk end panel.
10.Refer to Illustration 5. Use the flat blade screwdriver to
adjust levelers until top of pedestal is flat against desk
top.
11. Reinstall lock bracket.
12.Reinstall pedestal drawers.
IMPORTANT
If positioning pedestal under a credenza or return, do not
attach spacer blocks to rear of pedestal. Go to Step 9 and
and complete pedestal installation.
Mounting tape used to secure spacer blocks is extremely
sensitive and designed for permanent installation.
Attempting to remove spacer blocks after installation will
damage mounting tape and/or pedestal.
~