HON PERPETUAL User manual

TRAPEZOID TABLE
INSTALLATION INSTRUCTIONS
42-2804C (1/06)

PARTS
42-2804C (1/06)
1 of 2
Read all instructions and review illustrations before
installing.
TOOLS REQUIRED FOR ASSEMBLY
open end wrench (included)
6mm Allen wrench (included)
DESCRIPTION QUAN.
Atable top (style varies) 1
Bleg assembly 2
Chex screw 4
D glide 2 or 4
Eglide extension 2 or 4
Fswivel caster, non-locking 0 or 2
Sharp edges may cause injury. Take care when han-
dling metal parts.
Heavy panels can pinch or crush fingers. Do not place
fingers between or under panels during assembly.
WARNING

TRAPEZOID TABLE ASSEMBLY
42-2804C (1/06)
2 of 2
1PT3060 and PT2448 Assembly Instructions (refer to
Illustration 1):
1. Use two or more people to lay table top upside down
onto cardboard or a carpeted surface. Table top may be
different than shown in illustration.
2. Use the included 6mm Allen wrench to attach leg
assemblies (B) to top support bars using hex screws
(C, from hardware pack) as shown.
3. Install two swivel casters (F, from hardware pack) into
front of leg assembly. Turn casters clockwise until they
are flat against leg assembly.
4. Use included open end wrench to fully tighten casters.
5. Install glides and glide extensions (D and E, from hard-
ware pack) into rear of leg assembly. Turn clockwise
until they are flat against leg assembly.
6. Use two or more people to set table upright.
2PT3066 Assembly Instructions (refer to Illustration 2):
1. Use two or more people to lay table top upside down
onto cardboard or a carpeted surface.
2. Use the included 6mm Allen wrench to attach leg
assemblies (B) to top support bars using hex screws
(C, from hardware pack) as shown.
3. Install two swivel casters (F, from hardware pack) into
front of leg assembly. Turn casters clockwise until they
are flat against leg assembly.
4. Use included open end wrench to fully tighten casters.
5. Install glides and glide extensions (D and E, from hard-
ware pack) into rear of leg assembly. Turn clockwise
until they are flat against leg assembly.
6. Use two or more people to set table upright.
IMPORTANT
For proper stability of this table, glides, glide extensions,
and casters must be installed as defined in these assem-
bly instructions.
IMPORTANT
For proper stability of this table, glides, glide extensions,
and casters must be installed as defined in these assem-
bly instructions.

w w w . h o n . c o m
© The HON Company. HON is a reg-
istered trademark and Define Your
Space and Perpetual are trademarks.
The HON Company
200 Oak Street
Muscatine, Iowa 52761
Phone: [phone]
Customer Service Phone: [phone]
Customer Service Fax: [phone]