HON Ceres Use and care manual

Ceres Multipurpose – Seat Upholstered Assembly
Replacement Instructions
Items Required:
1 – New Seat Upholstered Assembly:
Applicable Part No’s: 92-3550XX, 92F3550XX, 92-3564XX, 92F3564XX, 92L3565XX
#2 Phillips Screwdriver or Equivalent
7 - #10 HI-LO Screw (Part No: 50-9719) – May use existing seat assembly screws on chair.
1. Tilt Ceres Multipurpose chair or place Ceres chair on elevated surface for removal of
seat assembly (See Figure 1 below).
Figure 1
Page 1
56-0121 Rev. A
The HON Company
200 Oak Street
Muscatine, IA 52761
800-833-3964
hon.com

2. Use Phillips screw driver to remove the (7) screws connecting the seat bottom cover
and the seat upholstered assembly on the Ceres Multipurpose chair (See Figure 2).
3. Remove seat bottom cover and pull seat assembly from Ceres Multipurpose chair.
4. Take new seat assembly and center the seat assembly with the Ceres Multipurpose
frame (see Figure 3). Make sure the seat assembly is positioned under the frame.
Figure 2
Figure 3
Page 2
56-0121 Rev. A
The HON Company
200 Oak Street
Muscatine, IA 52761
800-833-3964
hon.com

5. Place the seat bottom cover on top of the Ceres Multipurpose frame. Make sure all
(7) fastener points on the bottom cover line up with the seat assembly (see Figure 4).
Fasten all (7) screws to attach the seat bottom cover with the seat assembly.
Figure 4
Page 3
56-0121 Rev. A
The HON Company © 2011 The HON Company
200 Oak Street H4010 (01/11)
Muscatine, IA 52761HON is a registered trademark
800-833-3964 of HNI Technologies, under license
hon.com to The HON Company.