HON Ceres User manual

Ceres – Arm Pad Replacement Instructions
Tools Required:
1 New Arm Pad (P/N 95-3925)
Arm Assembly
1/8” Allen Wrench or Equivalent
1. Push the arm pad to its furthest depth position, with the majority of the arm pad
positioned towards the back of the arm.
2. Adjust the width position of the arm pad to expose the two fasteners on the right side
of the arm pad (see Figure 1 below). Remove the two fasteners with the 1/8” allen
wrench:
1/8” Allen Wrench
Page 1
56-0125 Rev. A
The HON Company
200 Oak Street
Muscatine, IA 52761
800-833-3964
hon.com

3. Push the arm pad forward so that the arm pad is at the second most forward position.
4. Adjust the width position of the arm pad to expose the two fasteners on the left side
of the arm pad (see Figure 2 below). Remove the two fasteners with the 1/8” allen
wrench:
Figure 1
Figure 2
Page 2
56-0125 Rev. A
The HON Company
200 Oak Street
Muscatine, IA 52761
800-833-3964
hon.com

5. Pull the arm pad away from the arm assembly and replace with a new arm pad (see
Figure 3). Use the same fasteners (if possible) with replacingthe arm pad. Use 1/8”
allen wrench to assemble fasteners to new arm pad (Figure 4).
Figure3
Figure 4
Page 3
56-0125 Rev. A
The HON Company © 2011 The HON Company
200 Oak Street H4010 (01/11)
Muscatine, IA 52761HON is a registered trademark
800-833-3964 of HNI Technologies, under license
hon.com to The HON Company.