Honeywell CL152 User manual

Portable Evaporative Air Cooler
User Manual
Read and save these instructions before use
EN Portabel Evaporativ Luftkylare
Luftkylare Användarmanual
Läs och spara dessa instruktioner innan användning
SE
Draagbare Verdamping Luchtkoelers
Gebruiksaanwijzing
Lees de gebruiksaanwijzing zorgvuldig en
bewaar deze goed
NL Przenośny Parowy Klimator
Instrukcja obsługi
Przeczytaj i zachowaj tę instrukcję przed użyciem
PL
Enfriador de Aire Evaporativo Portátil
Manual de Usuario
Lea y guarde estas instrucciones antes
de usar la unidad
ES Siirrettävät Höyrystävät Ilmanjäähdyttimet
Käyttäjän Opas
Lue ohjeet ennen käyttöä ja säästä ne
FI
Raffrescatori Evaporativi Portatili
Manuale Utente
Leggere attentamente le istruzioni prima
dell'utilizzo dell'apparecchio
IT Мобильная Климатическая Установка
Руководство пользователя
Прочтите и сохраните эту инструкцию перед
использованием
RU
Portátil por Evaporação Ventilador do Ar
Manual do Utilizador
Leia e guarde estas instruções antes da utilização
PT
Refroidisseur d'air par évaporation portatif
Mode d'emploi
Lire ces instructions avant l'utilisation et
les conserver
FR Transportabel Fordampende Luftkøler
Brugervejledning
Læs og gemme disse instrukser inden brug
DK
Tragbare Verdunstungs Luftkühler
Benutzerhandbuch
Lesen sie die anleitung vor dem gebrauch und
heben sie sie auf
DE Taınabilir Buharlı Sogutucu Kullanma
Kılavuzu
Kullanmadan önce bu talimatları okuyun ve
saklayın
TR
Model / Modèle / Modelo / Modello /
Mallien / Modeller / Modell / Мoдэль :
CL152
www.honeywellaircomfort.com
[e-mail]

1
PARTS DESCRIPTION
EN
1) Control Panel 7) Handle
2) Louvers 8) Rear Grill
3) Power Cord & Plug 9) Water Tank
4) Water Fill Door 10) Drain Plug
5) Water Level Indicator 11) Casters
6) Ice Compartment Lid 12) Honeycomb Cooling Media
16
7
8
9
10
3
2
4
11
5
12
WARNING -- READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND USER
MANUAL BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY
DAMAGE AND/ OR IMPAIR ITS OPERATION AND VOID THE WARRANTY. IN CASE THERE IS
ANY INCONSISTENCY OR CONFLICT BETWEEN THE ENGLISH VERSION AND ANY OTHER
LANGUAGE VERSION OF THE CONTENT OF THIS MATERIAL, THE ENGLISH VERSION SHALL
PREVAIL.

CONTROL PANEL
POWER
Press the or POWER button to turn the unit on. The cooler will start automatically at medium
speed. After a few seconds the speed will switch to low. To turn the unit off, press the button again.
SWING
Press the button until the indicator light is illuminated on the control
panel. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air
flow.
TIMER
Press the button until the desired time duration setting is selected. When the set time has passed,
the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged from
electrical socket). The function allows you to program the unit for up to 7.5 hours of use.
SPEED
Press the button repeatedly to change the speed between 3 (High) - 2 (Medium) - 1 (Low).
ION
Press the button until the ion indicator light is illuminated on the control panel.
Model with Ionizer *^
* Applicable for models with this feature only.
^ Ionizer reduces particles in the air. This is not an air purifier.
Model without Ionizer
Louver
Movement
FUNCTION BUTTONS
2
USE & OPERATION
EN

FUNCTION BUTTONS (CONTINUED)
WIND TYPE
COOL
Press the COOL button until the COOL indicator light is illuminated on the control panel. This
activates evaporative cooling. The water pump will operate and you will feel the cooler air after the
Honeycomb Cooling Media is completely wet.
Note: When the COOL indicator light is switched OFF, the unit can still function in a fan only mode
(without evaporative cooling).
Press the Wind button to select your desired wind type: Random or Sleep
Random: This mode mimic a natural breeze.
Sleep: This mode is for comfort during the night.
3
USE & OPERATION (CONTINUED)
EN

NOTE:
•
•
•
•
•
•
•
•
•
•
The remote control requires a CR2025 (1x3V) coin type or equivalent battery for replacement.
Open the battery compartment at the back of the remote control and insert batteries inside.
Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Do not recharge the battery.
Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
Model with
Ionizer*^
* Applicable for models with this feature only.
^ Ionizer reduces particles in the air. This is not an air purifier.
Model without
Ionizer
ON / OFF
Low / Medium / High
Controls the motion of the louvers
Controls the Timer function for automatic off
Controls cooling or fan option
Switch between Random & Sleep
Switch ON/OFF the Ionizer
POWER:
SPEED:
SWING:
TIMER:
COOL:
WIND TYPE:
ION:
4
REMOTE CONTROL
USE & OPERATION (CONTINUED)
EN

5
USE & OPERATION (CONTINUED)
EN
Make sure to position the air cooler correctly before you set up and start using the product.
Please refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
CAUTION:
Unplug the unit from the electrical power outlet before emptying or
refilling the water tank.
Open the Water Fill Door.
The Water Level Indicator is located at the front of the unit. Refill the
water tank when water level is low. Do not fill water above the "Max." water
level mark to avoid water droplets collecting on the louvers. Check the
water level in the tank before running the COOL function. Make sure that
the water in the tank is above the minimum water level mark. Running the
unit in COOL mode with inadequate water may cause pump failure.
Note: The water capacity refers to the total volume of water that can be
contained within the air cooler water tank and water distribution system.
The water capacity in the tank at the “Max.” indicator level may be lower
than the actual water capacity of the air cooler.
Note: If ice is available, you may add ice in the top ice compartment to
enhance the cooling performance.
WARNING: Do not fill water tank with dirty water or salt water. This can
damage the unit and Honeycomb media.
COOLER LOCATION
FILLING WITH WATER
Ice Compartment
Water
Fill Door

6
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for
a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the
separate Safety & Maintenance Guide.
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
USE & OPERATION (CONTINUED)
EN
CLEANING & DRAINING THE WATER TANK
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
Refill the water tank with clean water and drain it completely.
Refill the water tank with clean water, up to the maximum level.
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
When the product is not in use, store the unit in a dry place out of direct sunlight.
•
•
•
•
•
The unit is equipped with a low water sensor. In Cooling Mode, when water in the tank is below the
minimum level, you will hear a beeping sound and the indicator light will flash continuously. The unit
will automatically pause evaporative cooling.
Refill the water tank to deactivate the alarm in cooling mode. First switch OFF the unit and unplug
from the power outlet. Fill the water tank with water above the minimum water level mark. Plug in and
switch ON again.
To deactivate the alarm and continue using the unit as a fan (without evaporative cooling), switch
the unit OFF and then ON again. The Low Water Alarm will not activate in Fan only mode. The Low
Water Alarm will sound again if the COOL function is activated while the water tank is still empty.
*Applicable for models with Low Water Alarm feature only.
LOW WATER ALARM*

7
USE & OPERATION (CONTINUED)
EN
CLEANING THE CARBON DUST FILTER* & MESH FILTER AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* & Mesh Filter and Honeycomb Cooling
Media.
The Carbon Filter* & Mesh Filter and Honeycomb Cooling Media are located inside the Rear Grill.
See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh
water at least once a week will help reduce mineral deposits. If mineral deposits remain on the
Honeycomb Cooling Media, the media should be removed and washed under fresh water. The
media should be cleaned every two months or sooner, depending on your needs.
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
•
•
•
•
•
Carefully pull out the rear grill from the cooler.
Slide out the Honeycomb Cooling media.
Slide out the Carbon Dust Filter* & Mesh Filter and
clean with water.
Replace or clean media with water and a damp cloth
as needed.
1.
2.
3.
4.
Removing the Carbon Dust Filter* & Mesh Filter / Honeycomb Cooling Media:
WARNING: DO NOT operate the Air Cooler when the
Rear Grill is removed from the Air Cooler, or if there is
a loose-fitting Rear Grill. Doing so can cause serious
injury or dangerous electrical shock.
Figure 1:
Honeycomb
Frame Carbon Dust
Filter*
Rear Grill
Honeycomb
Cooling Media
Mesh
Filter
* Applicable for models with Carbon Dust Filter only.

1
DESCRIPTION DES PIECES
FR
1) Panneau de Contrôle 7) Poignée
2) Grilles d'Aération 8) Grille Arrière
3) Cordon Electrique & Prise 9) Réservoir d'Eau
4) Porte de Remplissage d'Eau 10) Bouchon de Vidange
5) Indicateur de Niveau d'Eau 11) Roulettes
6) Couvercle du Compartiment
de Glaçon 12) Système de Refroidissement Honeycomb
AVERTISSEMENT -- LIRE ET SAUVEGARDER LE GUIDE DE SECURITE ET D'ENTRETIEN ET LE
MANUEL D'UTILISATION DU REFROIDISSEUR D'AIR AVANT D'UTILISER LE PRODUIT. NE PAS
SUIVRE CES INSTRUCTIONS POURRAIT ENDOMMAGER ET/OU PORTER ATTEINTE A SON
FONCTIONNEMENT ET ANNULER LA GARANTIE.
16
7
8
9
10
3
2
4
11
5
12

PANNEAU DE CONTROLE
INTERRUPTEUR
Appuyer sur pour allumer l'unité. Le refroidisseur s'allumera automatiquement à une vitesse
moyenne. Après quelques seconds, la vitesse basculera à faible. Pour éteindre l'unité, appuyez à
nouveau sur le bouton.
OSCILLATION
Appuyer sur le bouton OSCILLATION jusqu’à ce que l’indicateur
d’OSCILLATION soit illuminé sur l’écran d’affichage. Les grilles d’aération
commenceront à osciller de gauche à droite automatiquement. — Débit d’air
vertical – il est possible de régler manuellement les grilles d’aération verticales
pour modifier le débit d’air vertical.
MINUTERIE
Appuyer le bouton de la MINUTERIE jusqu'à ce que le réglage de temporisation désiré est choisi.
Lorsque le temps réglé est dépassé, l'unité s'arrêtera automatiquement (l'unité restera en mode
Veille jusqu'à ce que le cordon d'alimentation soit débranché de la prise électrique). La fonction de
MINUTERIE vous permet de programmer l'unité jusqu'à 7.5 heures d'utilisation.
SPEED
Appuyer sur le bouton de la VITESSE à plusieurs reprises pour changer la vitesse entre 3(Élevée)-
2(Moyenne) - 1(Faible).
ION
Appuyez sur le bouton jusqu'à ce que le voyant ionique s'allume sur le panneau de commande.
Modèle avec ioniseur*^
* Applicable uniquement pour les modèles avec la fonction.
^ Le ioniseur réduit les particules dans l'air. Reduces particles in the air. Ce n'est pas un purificateur d'air.
Modèle sans ioniseur
Mouvement des
grilles d’aération
BOUTONS DE FONCTION
2
UTILISATION & FONCTIONNEMENT
FR