HPRT HM-T300 User manual

Quick Start Guide
HM-T300
Packing List
Quick Start Guide
Printer USB Cable
Appearance and Components
Font
Back
Paper Loading
1.Press the cover open buon to open the printer cover.
Roll Paper
Baery
Inside
Platen
Cuer
USB Interface
Thermal Head
Paper Roll Perspecve
Window
[FEED] Buon
[MODE] Buon
Power LED
Error LED
Cover Open Buon
LCD
Baery
AC Adapter
Belt Clip
CD
Thermosensive layer
Belt Clip Screw Hole
2.Load the roll paper in the orientaon shown in the figure
below.
Xiamen Hanin Electronic Technology Co.,Ltd
ADD:
TEL:
FAX:
WEB:
Room 305A,Angye Building,Pioneering Park,
Torch High-tech Zone,Xiamen,China.
[phone]
[phone]
www.hprt.com
！Notes:
1.The packing materials are actually dependent on the order.
2.The AC adapter vary by local or region.

2.Press and hold MODE & FEED buons, release the buons
aer you surely confirm the screen display“Enter Menu Mode”,
to get a printer into the seng mode.
3.Press the MODE buon, choose the item or return to
previous menu.
4.Press the FEED buon, you can move the cursor(“_”) or
confirm the new seng.
RP
Printer Status：
Online
◆Before changing the menu seng, please make sure that the
communicaon with a host device is disconnected.
◆When the printer is under the Bluetooth communicaon with
a host device, it cannot enter the Menu Seng mode.
Note
3.To remove the baery back, pull back the hook, and use the
opposite procedure from the one you used to insert the
baery pack.
Plug in socket with USB charging.
When baery pack runs out of power, the baery icon will
flash. It powers off automacally when connues prinng.
If you want to go on, please charge it.
◆POWER lamp will always flash in green color and goes off
when fully charged.
◆Charging the printer when it is on, even if baery icon on
the LCD shows fully charged, turn off the printer and let the
baery charge unl the POWER lamp goes off for fully charge.
Note
Charging via AC Adapter
Charging via PC
3.Pull the end of the roll straight toward you. Then press down
on both sides of the printer cover to close it firmly. When you
close the printer cover,make sure that it is closed on both sides.
4.Use the tear bar to cut the extra paper.
Baery Installaon
Baery Charging
1.Make sure that the printer has been turned off before you
insert or remove the baery pack.
2.Insert the baery pack into the back of the printer as in the
figure shown below, following the direcon of the arrow.
Press down on the baery pack unl the hook click into place.
Menu Sengs
1.Press and hold MODE buon for approx. 2 seconds, and
printer is turned on. LCD display is shown as follows.
Hook