Huawei B315 LTE CPE User manual

Self help and Huawei
B315 LTE setup

The following items are supplied in your box.
Remove the SIM cover of the router.

Insert the power supply into the power supply source.
Insert the SIM card into the router and replace the cover.
Connect the power supply cable to the router.

Make sure the power light is on.
Attach both aerials to the router.
Plug the LAN cable to the rst port of the router marked LAN.

Plug the other end into a LAN port on your computer.
Plug a telephone cable into the port of the router marked T-E-L or TEL.
Plug the other end of the cable into a telephone.

This is a battery backup in case of any power outages.
Remove the power plug from the router and plug it into the battery back-up.

Open your browser and type 192.168.8.1 into the address bar and press enter.
Now connect the battery back up cable to the router.

Select settings and type in admin for both username and password, then click log in.
Click on new prole
to congure the FLLA prole.

Enter FWB on prole name and Telkominternetla on the APM.
Click save and next. The APM is case sensitive so enter it as indicated above.
Click next on the following page.

You may use the default SSID and key found underneath the modem by skipping this
step and clicking nish or you can change the key as indicated in the next section.
Edit your SSID name to your preferred Wi-Fi name and edit the WPA pre-shared key to
your preferred key. It is recommended to set a key of a minimum of 8 characters. Click
nish.
After waiting a while, the message will pop up conrming that your settings have been
saved. Close the pop-up window.