HUSKY LINERS 4028 Manual

4028.DOC
Rev: 0
02/07/01
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll
and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a
weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this
“relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of Armor
All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHRYSLER PT
CRUISER CARGO LINER
YOUR NEW HUSKY LINER CAN BE USED WITH OR WITHOUT THE FACTORY SECOND SEATS INSTALLED.
TO USE WITH THE SECOND SEATS IN PLACE, THE AREAS SHOWN CIRCLED ABOVE MUST BE TRIMMED
TO ALLOW THE SEATS TO ATTACH TO THE FLOOR. USING A UTILITY KNIFE, TRIM AROUND THE INSIDE
OF THE RAISED BAND TO COMPLETE THE CUT-OUT (3 PLACES--SEE PHOTO ON BACK). NOW, JUST FOLD
THE SEATS UP, SECURING THEM USING THE FACTORY STRAPS AND PLACE THE LINER IN YOUR
VEHICLE.

4028.DOC
Rev: 0
02/07/01
PHOTOS OF #4028 TRIMMED FOR USE WITH THE SECOND SEAT
INSTALLED IN THE VEHICLE