HUSKY LINERS 6077FR Manual

6077FR~1.DOC
Rev: 0
01/10/01
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR SECOND SEAT DODGE
DAKOTA QUAD CAB FLOOR LINERS
IF YOUR QUAD CAB IS EQUIPPED WITH BUCKET SEATS, YOU MAY NEED TO TRIM YOUR LINER(S) TO
ALLOW FOR SEAT TRACK CLEARANCE DURING POSITIONING OF YOUR SEATS. INSTALL THE LINERS IN
YOUR VEHICLE AS DESCRIBED ABOVE MOVING YOUR SEATS THROUGH THEIR FULL RANGE OF POSITIONS.
IF INTERFERENCE OCCURS, TRIM YOUR LINERS AS NEEDED BY REMOVING THE MATERIAL IN THE RELIEF
AREA(S) PROVIDED ON YOUR LINERS (SEE ABOVE). TO TRIM, CUT AWAY THE OFFSET PORTIONS OF THE
RELIEF AREA(S) WHERE NEEDED (SEE PHOTO ON BACK). A UTILITY KNIFE OR HEAVY SCISSORS WORK
WELL FOR TRIMMING.
FRONT OF VEHICLE
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER

6077FR~1.DOC
Rev: 0
01/10/01
PHOTOS OF TRIMMED PART #6077
DRIVER’S SIDE
PASSENGER’S SIDE
PART #6077 TRIMMED TO ACCOMMODATE
SEAT TRACK