HUSKY LINERS 6620 Manual

6620 Front_Back.doc
Rev: 1
01/18/02
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place
of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing
your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®
work well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the
liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR NISSAN
FRONTIER TRUCK SECOND SEAT FLOOR LINER
FRONT OF VEHICLE
DUE TO DIFFERENCES IN SIZING OF FACTORY EQUIPPED CONSOLES, YOUR FRONTIER
EXTENDED CAB TRUCK LINER MAY NEED MINOR TRIMMING TO CORRECTLY FIT YOUR
TRUCK. FIRST, TEST FIT YOUR LINER. IF YOU FIND INTERFERENCE WITH THE CONSOLE,
PLEASE TRIM YOUR LINER AS SHOWN ABOVE. IF NECESSARY, THE TRIMMING IS EASILY
DONE USING THE RECESSED GROOVE AS A TRIM GUIDE. TRIMMING PHOTOS ARE
INCLUDED ON THE BACK OF THIS PAGE.

6620 Front_Back.doc
Rev: 1
01/18/02
TRIMMING PHOTOS OF PART #6620
PART #6620 SHOWN TRIMMED FOR FRONTIERS
TRUCKS WITH LONGER CONSOLE. TRIM USING
MOLDED IN GROOVE AS A GUIDE.
PART #6620 SHOWN UNTRIMMED FOR USE IN
FRONTIERS TRUCKS WITH SHORTER CONSOLE.