HUSKY LINERS 5730 User manual

PART NO. 5730
5730 Rear Instructions.doc
Rev: 0
95-02 CHEVROLET ZR2 S-10 PICKUP / GMC SONOMA HIGHRIDER TRUCK
REAR MUD GUARD SET
INSTALLATION INSTRUCTIONS
Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
Tools Required:
•1/8” drill bit / Drill
•Wrench (varies depending on vehicle)
•Center punch / Hammer
•Short Phillips screwdriver
•Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
•Driver & passenger side mud guard
•1” #10 screws (qty. 4)
•Paint protection film
•Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Using a Wrench, remove existing fastener from location A (see figure 1) (fastener type varies from vehicle to vehicle).
3. Attach mud guard to fender with existing fastener at location A, check fit and level before tightening.
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations B and C.
5. Attach mud guard to fender with #10 screws at locations B and C.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.

PART NO. 5730
5730 Rear Instructions.doc
Rev: 0
PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS
NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting
surfaces of your fenders against wear. The templates (left and right side) can be removed from the
backing liner by folding the liner at the center cut of the template, separating the film sides and peeling
the film templates from the backing liner.
1. Position mud guard on fender to indicate placement of paint protection film.
2. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner
such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry.
3. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent.
4. Mark correct position of film by placing mud guard against fender.
5. Remove protection film from liner and flood adhesive side of film with wetting solution (use a spray bottle
or sponge).
6. Thoroughly wet film placement location of fender with wetting solution.
7. Position the adhesive side of film on fender and flood with wetting solution.
8. Check location of film with mud guard and reposition as necessary.
9. Using a sponge, squeegee any air bubbles and wrinkles from film.
10. Allow film to dry before installing mud guard.