HUSKY LINERS 3231 Manual

3231 Front_Rear.doc
09/18/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place
of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your
new floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work
well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR S-10/BLAZER/
BRAVADA/ENVOY/HOMBRE/JIMMY/SONOMA FLOOR LINERS
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
SEE BACK OF THIS SHEET FOR ADDITIONAL INSTRUCTIONS.

3231 Front_Rear.doc
09/18/03
Your Husky Floor Liners come molded with Sta-Put Nibs® on the back surface of the liners to help hold them
in place. Additionally, we have included an optional Velcro® anchoring system to further secure your driver’s
side liner. To install the optional Velcro® anchoring system, just follow the easy steps listed below.
First, Locate the hardware bag included in the shipping container. Inside it you will find 2 anchor screws with
the “loop” pad portion of the Velcro® fasteners already applied. Also included are two Velcro® hook pads that
will need to be applied to your liner.
Before positioning the Velcro® hook pads on your liner, it will be necessary to remove any nibs that would
keep the pads from laying flat. A pair of clippers work well for removing nibs. Photos 1 and 2 below show
where a nib has been removed and Velcro® hook pad has been installed. Install the hook pads towards the back
edge of the liner (nearest the seat) opposite of each other. Choose a flat area underneath which the carpet screw
can be installed (make sure the anchor screw will actually screw into the area chosen). Pre-fitting the liner may
help determine “good” locations.
Finally, install the liner in your vehicle making sure it is properly aligned. The anchor screws will need to be
installed in your factory carpet directly beneath the Velcro® hook patches you applied. To do this, pull up a
corner of your liner as shown in photo 3 below. Attach the anchor screw (the Velcro will hold the screw to the
liner) to the pad then lower the raised edge and note the position where the anchor screw touches the vehicle
carpet. Insert the anchor screw and repeat procedure for the other pad location.
PHOTO 1. ARROW POINTING TO
NIB THAT HAS BEEN REMOVED
TO ALLOW HOOK PAD TO LAY
FLAY.
PHOTO 3. ANCHOR SCREW SHOWN INSTALLED
IN CARPET ALIGNED BELOW HOOK PAD.
PHOTO 2. VELCRO® HOOK PAD
SHOWN ATTACHED TO LINER.