HUSKY LINERS 6365 Manual

6365 Front_Back.doc
10/08/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work
well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150
TRUCK SECOND SEAT FLOOR LINER
ON VEHICLES EQUIPPED WITHOUT A CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM AWAY A
PORTION OF THE LINER AS SHOWN ABOVE. TRIM BY REMOVING THE LOWERED SECTION OF THE
LINER ALONG THE FRONT EDGE AS SHOWN ABOVE. A UTILITY KNIFE OR SCISSORS WORK WELL FOR
TRIMMING. SEE BACK OF PAGE FOR TRIMMING PHOTOS.
RIGHT OR
PASSENGER’S
SIDE
LEFT OR
DRIVER’S
SIDE
NOTICE: DURING THE 2004 MODEL YEAR, FORD WILL PRODUCE TWO VERSIONS OF THE F-150 TRUCK.
THIS LINER IS DESIGNED SPECIFICALLY FOR ALL NEW F-150 (“NEW BODY” STYLE). THE OTHER 2004
FORD F-150 AVAILABLE IS THE “HERITAGE EDITION”, WHICH IS A CONTINUATION OF THE PREVIOUS
OR “OLD BODY” STYLE. IF YOU HAVE A 2004 HERITAGE EDITION TRUCK, YOU NEED HUSKY SECOND
SEAT LINER PART #6334.

6365 Front_Back.doc
10/08/03
6365 PART UNTRIMMED. USE UNTRIMMED
PART IN VEHICLE WITH FACTORY CENTER
CONSOLE BETWEEN FRONT SEATS.
6365 PART SHOWN TRIMMED. USE TRIMMED
PART IN VEHICLE WITHOUT FACTORY
CENTER CONSOLE BETWEEN FRONT SEATS.
PART #6365 SHOWN IN VEHICLE WITH FACTORY
CONSOLE. NOTE PART IS UNTRIMMED.
PART #6365 SHOWN IN VEHICLE WITHOUT
FACTORY CONSOLE. NOTE PART IS TRIMMED.