HUSKY LINERS 3577 Manual

3577.doc
04/17/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place
of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your
new floor liner. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work
well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR
LEXUS GX470 FRONT FLOOR LINERS
IF YOUR GX470 HAS THE DVD RSE (REAR SEAT ENTERTAINMENT) OPTION, YOU WILL NEED TO
TRIM YOUR PASSENGER SIDE LINER AS SHOWN ABOVE. TO EASE TRIMMING, A STEP IS
MOLDED INTO YOUR LINER AS A GUIDE (SEE PHOTO’S ON BACK OF PAGE). A UTILITY KNIFE
OR HEAVY SHEARS WORK WELL FOR TRIMMING.
THE FACTORY CARPET MAT RETAINING HOOKS LOCATED IN THE DRIVER’S SIDE
FLOORBOARD CAN EASILY BE REMOVED TO ALLOW YOUR LINER TO LAY COMPLETELY
FLAT. APPLY FIRM PRESSURE WHILE TIPPING THE HOOK ARMS STRAIGHT UP TO REMOVE
THEM.
LEFT OR
DRIVER’S
SIDE LINER
RIGHT OR
PASSENGER’S
SIDE LINER

3577.doc
04/17/03
PART #3577 SHOWN IN A GX470 WITHOUT OPTIONAL
REAR DVD/REAR ENTERTAINMENT SYSTEM (RSE)
PART #3577 SHOWN IN A GX470 WITH THE REAR DVD/RSE
SYSTEM (NOTE THAT PART HAS BEEN TRIMMED)
PART #3577 SHOWING TRIMMING
NECESSARY TO FIT VEHICLES
WITH REAR DVD/RSE SYSTEM