HUSKY LINERS 4707 User manual

H3 2 pc plastic cover instr
Hummer H3 Spare Tire Cover Installation
Thank you for the purchase of your new Hummer H3 spare tire cover. Please inspect your package contents
before beginning installation. Shown below is a list of installation hardware, faceplate, base plate and quantities:
Faceplate (1) Base Plate (1)
Latch Assembly and Insert Installation:
1. Install latch insert and latch to the spare tire base plate with screw, through the front side of an open latch,
into the predrilled holes on the base plate, and finally through the latch insert (textured side against base
plate). Fasten with a washer and nut using a flat head screwdriver and 5/16” wrench (fig 1). Repeat this
installation on each of the 4 notched and predrilled locations on the tire base plate (fig 2).
Latch (4)
Catch (4)
Latch
Insert (4)
Catch
Insert (4)
Washer
(16)
Nut
(16)
Screw
(16)
Key (1)

H3 2 pc plastic cover instr
fig 1 fig 2
2. Install catch insert and catch to the spare tire faceplate with screw through the front side of catch, into the
predrilled holes on the faceplate, and finally through the catch insert (textured side against faceplate).
Fasten with a washer and nut using a flat head screwdriver and 5/16” wrench (fig 3). Repeat this
installation on each of the 4 predrilled locations on the faceplate (fig 4).
fig 3 fig 4
Spare Tire Cover Installation:
3. Remove lug nuts and spare tire from spare tire rack (fig 5). Install Base Plate on lugs with the narrow
spaced latches at the top and the wide spaced latches at the bottom, this will allow for proper Faceplate
alignment (fig 6). Place tire on lugs and fasten lug nuts (fig 7).
4. Attach Spare Tire Faceplate with “C design” running horizontal from center to the right hand/ passenger
side of vehicle (fig 7). Check to be sure the “C design is running horizontal to the ground. If not simply
remove face plate, loosen lug nuts, adjust base plate by rotating the desired direction, tighten lug nuts and
reinstall face plate.

H3 2 pc plastic cover instr
fig 5 fig 6
fig 7 fig 8
NOTE: If you have the ADVENTURE Package with the larger 33-inch on/off road tires you will need to
complete the following before installation. Remove the 3” foam pads (4 total – fig 9) and the 18” foam strips
(4 total – fig 10) from the Spare Tire Base Plate. Pry up a corner of the pad/strip and peel slowly to ensure
that the entire pad is removed.
fig 9 fig 10