HUSKY LINERS 4713 User manual

H2 2 pc plastic cover instr
Hummer H2 Spare Tire Cover Installation
Thank you for the purchase of your new Hummer H2 spare tire cover. Please inspect your package contents before
beginning installation. Shown below is a list of installation hardware, faceplate, base plate and quantities:
Faceplate (1) Base Plate (1)
Latch Assembly and Insert Installation:
1. Install latch insert and latch to the spare tire base plate with screw, through the front side of an open latch, into
the predrilled holes on the base plate, and finally through the latch insert (textured side against base plate).
Fasten with a washer and nut using a flat head screwdriver and 5/16” wrench (fig 1). Repeat this installation on
each of the 3 notched and predrilled locations on the tire base plate (fig 2).
fig 1 fig 2
Latch (3)
Catch (3)
Latch
Insert (3)
Catch
Insert (3)
Washer
(12)
Nut
(12)
Screw
(12)
Key (1)

H2 2 pc plastic cover instr
2. Install catch insert and catch to the spare tire faceplate with screw through the front side of catch, into the
predrilled holes on the faceplate, and finally through the catch insert (textured side against faceplate). Fasten
with a washer and nut using a flat head screwdriver and 5/16” wrench (fig 3). Repeat this installation on each
of the 3 predrilled locations on the faceplate (fig 4).
fig 3 fig 4
Spare Tire Cover Installation:
3. Remove License Tag Holder from spare tire.
4. Remove lug nuts and spare tire from spare tire rack (fig 5). Install Base Plate on lugs with one latch located
center bottom, this will allow for proper Faceplate alignment (fig 6). Place tire on lugs and fasten lug nuts (fig
7).
5. Attach Spare Tire Faceplate and reinstall License Tag Holder (fig 8).
fig 5 fig 6

H2 2 pc plastic cover instr
fig 7 fig 8