HUSKY LINERS 6595 Manual

6595 Front_Back.doc
12/09/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way
to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of Armor
All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR
TOYOTA RAV-4 SECOND SEAT FLOOR LINERS
FRONT OF VEHICLE
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER
1
SOME 2004 RAV4’S HAVE CONSOLES THAT ARE LONGER AND EXTEND BACK FURTHER INTO THE
SECOND AREA. TO ACCOMMODATE THE LONGER CONSOLES, A TRIM AREA IS INCORPORATED INTO
YOUR LINER. SIMPLY FIT YOUR LINER IN YOUR VEHICLE, IF YOU NOTE INTERFERENCE WITH THE
CONSOLE, YOU CAN EITHER TUCK YOUR LINER UNDER THE CONSOLE OR TRIM OUT THE LOWERED
AREA LOCATED ALONG THE FRONT EDGE OF THE LINER WHERE IT MEETS THE CONSOLE (SEE AREA
“1” ABOVE AND PHOTO ON BACK OF PAGE). A UTILITY KNIFE OR HEAVY SHEARS WORK WELL FOR
TRIMMING.

6595 Front_Back.doc
12/09/03
TRIMMING PHOTOS OF PART #6595
PART #6595 SHOWN UNTRIMMED. COMPLETE TRIM
BY REMOVE RECESSED PORTION OF LINER.
PART #6595 SHOWN TRIMMED..