HUSKY LINERS 7391 Manual

7391.doc
Rev: 0
03/22/02
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR THIRD
SEAT FORD EXCURSION FLOOR LINERS
FRONT OF VEHICLE
EXCURSION OWNERS WITHOUT SECOND ROW CAPTAIN’S CHAIRS WILL NEED TO TRIM AWAY THE AREA
SHOWN DARKENED BELOW. A TRIM GROOVE IS MOLDED IN TO USE AS A GUIDE. THE “TONGUE” SHOWN
TRIMMED CAN ALSO BE REMOVED OR TUCKED UNDER THE SECOND ROW BENCH SEAT. TRIMMING
PHOTOS ARE INCLUDED ON THE BACK OF THIS PAGE.
*TO AID INSTALLATION, SLIDE THE SECOND
SEATS TO THEIR MOST FORWARD POSITION.

7391.doc
Rev: 0
03/22/02
TRIMMING PHOTO OF PART #7391
PART #7391 SHOWN TRIMMED FOR VEHICLES EQUIPPED WITH SECOND ROW
60/40 SPLIT BENCH SEATS. REMOVAL OF AREA 1 IS REQUIRED. REMOVAL OF
AREA 2 IS OPTIONAL. “ TONGUE” WILL SLIDE UNDER SECOND ROW SEAT.