HUSKY LINERS 7379 Manual

7379_Front_Back.doc
02/05/2006
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat(s) before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR THIRD SEAT
FORD EXPLORER/MERCURY MOUNTAINER FLOOR LINER
(WITH SECOND ROW BUCKET SEATS)
FRONT OF VEHICLE
TO INSTALL YOUR LINER, JUST RELEASE AND FOLD FORWARD BOTH SECOND ROW BUCKET SEATS
(IF YOU DO NOT HAVE BUCKET SEATING, YOU WILL NEED HUSKY LINER PART #7377 FOR YOUR
VEHICLE). ONCE BOTH SEATS ARE FOLDED FORWARD, YOU CAN INSTALL YOUR LINER. THE SECOND
ROW SEATS WILL REATTACH THROUGH THE FOUR (4) HOLES IN THE LINER (SHOWN ABOVE
DARKENED.
NOTICE: IF THE FOUR (4) AREAS SHOWN DARKENED ABOVE ARE NOT TRIMMED OUT WHEN YOU
RECEIVE YOUR LINER, YOUR SEATS WILL NOT BE ABLE TO LOCK INTO PLACE AND THE LINER
SHOULD NOT BE INSTALLED. IF YOUR LINER IS NOT TRIMMED IN THESE FOUR AREAS, PLEASE CALL
US AT 800-344-8759.
TO ACCESS THE CHILD SAFETY SEAT HOOKS WITH YOUR LINER IN PLACE, SIMPLY TRIM THE
MATERIAL AWAY FROM THE TWO (2) LOWERED AREAS LOCATED ALONG THE BACK WALL OF THE
LINERS (SHOWN CIRCLED ABOVE—SEE PHOTO ON BACK OF THIS PAGE).

7379_Front_Back.doc
02/05/2006