HUSKY LINERS 6575 Manual

6575.doc
04/14/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take
the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mats
before installing your new floor liner. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass
Plus®work well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products
make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA
4RUNNER SECOND SEAT FLOOR LINER
IF YOUR 4RUNNER IS EQUIPPED WITH THE FACTORY POWER SEAT OPTION, IT MAY BE
NECESSARY TO TRIM YOUR LINER TO AVOID INTERFERENCE WITH THE SEAT TRACKS. TO
DETERMINE IF TRIMMING IS NECESSARY, FIRST INSTALL YOUR LINER, POSITIONING IT IN
YOUR VEHICLE AS SHOWN ABOVE. TO EASE INSTALLATION, MOVE THE SEATS TO THEIR MOST
FORWARD POSITION BEFORE INSTALLING THE LINER. ONCE THE LINER IS IN PLACE, MOVE THE
SEATS SLOWLY BACK, CHECKING FOR INTERFERENCE WITH THE LINER. IF INTERFERENCE
OCCURS, TRIM AWAY THE MATERIAL IN THE TWO LOWERED AREAS ON THE LINER AS SHOWN
ABOVE AND ALSO IN THE PHOTOS ON THE REVERSE SIDE OF THIS PAGE. TRIMMING IS EASILY
DONE USING A UTILITY KNIFE OR HEAVY SHEARS.
FRONT OF
VEHICLE

6575.doc
04/14/03
PHOTOS SHOWING TRIMMING NECESSARY FOR POWER SEAT OPTION