HUSKY LINERS 6510FR Manual

6510FR~1.DOC
Rev: 1
02/01/01
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liners are made to take the place of your
factory floor mats. For correct fit it is necessary to remove the factory floor mats before installing your new floor
liners. However, do not remove the factory installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA TACOMA
SECOND SEAT LINER
TACOMA’S EQUIPPED WITH A CENTER CONSOLE WILL NEED TO HAVE THEIR HUSKY LINERS TRIMMED TO
ALLOW PROPER FIT. TRIM LINER FOLLOWING THE SCRIBED LINES ON THE PASSENGER SIDE LINER’S HUMP
PORTION, PASSING APPROXIMATELY _” ABOVE THE RAISED BAND BISECTING THE TREADED AREA ON THE
HUMP (SEE ABOVE). A UTILITY KNIFE OR HEAVY SHEARS WORK WELL FOR TRIMMING. A PHOTO ON THE
BACK SHOWS A TRIMMED PART.
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER
FRONT OF VEHICLE
LEFT OR
DRIVER’S SIDE RIGHT OR PASSENGER’S SIDE
NOTICE: LEFT LINER
OVERLAPS RIGHT LINER

6510FR~1.DOC
Rev: 1
02/01/01
PART NUMBER 6510 TOYOTA TACOMA SHOWN TRIMMED FOR
FACTORY CENTER CONSOLE