HUTTON ACA User manual

garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructions
ACA – Avon Corner Arbour
1. Using the provided screws, fix the trellis panel with 2
long posts to the panel with 1 long post to create the
corner. The trellis needs to be flush on the inside of all
panels.
2. Using 95mm bolt and connector cap, fix the top of one
backrest to one of the long trellis sections, & using a
60mm bolt, fix the other side of the backrest into the
insert in the corner section.
3. Next bolt the other backrest to the remaining long
trellis section and bolt to the other post of the corner
section.
4. Line up the holes at the back of the seat rest with the
bottom holes of the back rest and the holes in the
arbour posts and, using 95mm bolts and connector
caps, fix into place.
5. Fix the front of the seat into the front post of the long
trellis section and repeat 4 and 5 for the other seat
rest.
When assembling, loosely bolt together until
fully assembled then tighten all the bolts.
This will require at least 2 people
to assemble. Power screwdriver will
also be helpful.
List of parts in fixings pack
50 x 70mm Screws
4 x 80mm Screws
8 x 95mm Connector Bolts
8 x 60mm Connector Bolts
8 x 25mm Connector Caps
4 x Rubber Bungs
2 x Allen Keys
1 x Square Bit
List of parts
Side panels with trellis
Corner trellis section with 2 posts
Corner trellis section with 1 post
x2 trellis panels
Bac rests
Seat rests
Table leg
Table
Top Rail Section 1
Top Rail Section 2
continued over....

6. Place the small corner table post into place with 2
inserts alinged to the holes on the seat rests and fix
into place with the 2 remaining 60mm bolts.
7. Place table section supported by the leg. Make sure it is
level and screw into place with 80mm screws from the
back of the trellis framing into the table.
8. At this point fit the trellis panels to go above the back
rests, fix into place using 70mm screws so the top of
the trellis frame is at the same level as the other trellis
panels.
9. At this point all the bolts can be fully tightened.
10. Place the top section with one long rail and one shorter
rail into place and screw into the top of the arbour
posts. (Use 2 x 70mm screws in each post). Next screw
the other top section into place. our arbour should
now look like the picture opposite.
garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructions
ACA – Avon Corner Arbour
Hutton Garden and Landscaping Products
Church Lane, Northwood Green, Westbury-0n-Severn, Gloucestershire GL14 1ND www.svw2000.co.u /hutton
Tel: [phone] Fax: [phone] [e-mail]