HUTTON DSM User manual

Assembly Instructions
DSM - Melrose Dining Set
1. Place the table top upside down on a
clean level surface. Taking care to protect
the table top from scratching.
2. Slot in a leg set on either side making sure
that the leg braces are facing inwards.
3. Through the braces attached to the table
screw into each leg using 3 screws in
each leg.
4. Turn table the correct way up and slot the
cross brace onto the leg braces. Screw
into place through the pre-drilled holes.
5. Place seat board upside down on a clean
level surface. Taking care to protect the
seat boards from scratching.
6. Slot in a leg set on either side making sure
that the leg braces are facing inwards.
7. Through the braces attached to the legs
screw into each seat using 3 screws.
List of parts in fixings pack
----------------------------------------------------------------------------------
44 x 90mm Screws
List of parts
---------------------------------------------------------------------------------
1 x Table Top
2 x Table Leg Sets
2 x Seat Sections
4 x Seat Legs
2 x Table Cross Brace
IMPORTANT CUSTOMER INFORMATION
To minimise twisting and warping all Hutton garden furniture products should only be used on firm level ground.
Softwood is a natural material which can twist and split during periods of wet/dry, hot/cold weather. If cracks do appear it is a
natural occurrence and not a fault with the product or material. The best way to treat this is to use a cloth and rub a little PVA
wood glue into the crack and once dry sand the area lightly. This will not affect the treatment of the product.
Hutton Garden and Landscaping Products
Church Lane, Northwood Green, Westbury-on-Severn, Gloucestershire GL14 1ND www.svw2000.co.uk/hutton
Tel: [phone] Fax: [phone] [e-mail]
When assembling, loosely fix together until fully assembled then tighten all the fixings.

Photo 1
Photo 2
Box Parts