HUTTON Avon Corner Arbour User manual

garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructions
ACA – Avon Corner Arbour
1. Using the provided screws, fix the trellis panel with
2 long posts to the panel with 1 long post to create
the corner. The trellis needs to be flush on the
inside of all panels.
2. Using 95mm bolt and connector cap, fix the top of
one backrest to one of the long trellis sections, &
using a 60mm bolt, fix the other side of the
backrest into the insert in the corner section.
3. Next bolt the other backrest to the remaining long
trellis section and bolt to the other post of the
corner section.
4. Line up the holes at the back of the seat rest with
the bottom holes of the back rest and the holes in
the arbour posts and, using 95mm bolts and
connector caps, fix into place.
5. Fix the front of the seat into the front post of the
long trellis section and repeat 4 and 5 for the other
seat rest.
When assembling, loosely bolt together until
fully assembled then tighten all the bolts.
This will require at least 2 people
to assemble. Power screwdriver will
also be helpful.
List of parts in fixings pack
50 x 70mm Screws
4 x 80mm Screws
8 x 95mm Connector Bolts
8 x 60mm Connector Bolts
8 x 25mm Connector Caps
4 x Rubber Bungs
2 x Allen Keys
1 x Square Bit
List of parts
Side panels with trellis
Corner trellis section with 2 posts
Corner trellis section with 1 post
x2 trellis panels
Bac rests
Seat rests
Table leg
Table
Top Rail Section 1
Top Rail Section 2
continued over....

6. Place the small corner table post into place with 2
inserts alinged to the holes on the seat rests and fix
into place with the 2 remaining 60mm bolts.
7. Place table section supported by the leg. Make
sure it is level and screw into place with 80mm
screws from the back of the trellis framing into the
table.
8. At this point fit the trellis panels to go above the
back rests, fix into place using 70mm screws so the
top of the trellis frame is at the same level as the
other trellis panels.
9. At this point all the bolts can be fully tightened.
10. Place the top section with one long rail and one
shorter rail into place and screw into the top of the
arbour posts. (Use 2 x 70mm screws in each post).
Next screw the other top section into place. Your
arbour should now look like the picture opposite.
garden and landscaping products
HH
UTTOUTTO
NN
Assembly Instructions
ACA – Avon Corner Arbour
Hutton Garden and Landscaping Products
Church Lane, Northwood Green, Westbury-0n-Severn, Gloucestershire GL14 1ND
www.svw2000.co.u /hutton
Tel: [phone] Fax: [phone] [email protected]
IMP RTANT CUST MER INF RMATI N
To minimise twisting and warping all Hutton garden furniture products should only
be used on firm level ground.
Softwood is a natural material which can twist and split during periods of wet/dry,
hot/cold weather. If cracks do appear it is a natural occurrence and not a fault
with the product or material. The best way to treat this is to use a cloth and rub a
little PVA wood glue into the crack and once dry sand the area lightly.
This will not affect the treatment of the product.