ICP DAS USA XP-9 88-IoT Series User manual

P1
XP-9x88-IoT Quick Start
v2.2, Jun. 2023
Packing List
Apart from this guide, this package includes following items:
XP-9188-IoT
XP-9388-IoT
XP-9788-IoT
CF slot with
a CF card
Screwdriver
Resources
How to search for drivers, manuals and spec information from ICP DAS website.
For Desktop Browser
For Mobile Web
Technical Support
[e-mail]
www.icpdas.com
Model Name
CF
Model Name

P2
1 Configure the Boot Mode
Before starting the installation, ensure that the
rotary switch is set into the “0” position.
2 Connecting to PC, Monitor and Power Supply
3 Insert the I/O Module and Wiring
XP-9x88-IoT with 1/3/7 expand slots support
high profile I-9K and I-97K series I/O modules.
For more information about expansion I/O
modules, please refer to our website.

P3
4 Use PAC Utility to Manage the XP-9x88-IoT
1) Double-click the shortcut of “PAC Utility” on the PAC desktop.
2) Double click the “Internet Access” icon on the task bar. Click “Ethernet”
and select IPV4.
3) Click on “Properties” button and select “Use the following IP Address”. Key
in the IP address, subnet mask, and default gateway.
4) Click “OK” to save all changes.

P4
5 Use DCON Utility Pro to Configure I/O Modules
1) Double-click the shortcut of “DCON Utility Pro” on the desktop.
2) Click the button.
3) Configure the communication settings.
4) Click the button.
5) Click the module name to configure the I/O module.

P5
6 Changethe Language
1) Select “Start”, choose “Settings”, click “Control Panel”, and then click
Regional Settings.
2) Click “User Interface Language” tab, drop down to select the language, and
click OK.
3) Run the PAC Utility, and then reboot the PAC to save all changes.

P6
7 Version Identification
The XP-9x88-IoT can only support latest version of Workbench
and Runtime:
•Workbench 11.0 above with Runtime Ver. 2.xx (factory
default)
Figure for Version confirmation
Workbench 11.0
Runtime Ver. 2.xx
Note: Win-GRAF runtime must be matched with Win-GRAF Workbench V11
(or later)

P7
8 Download the Latest Win-GRAF Workbench
V11 Along with the Runtime
Key in “win-graf” into Search Box at ICP DAS home page. Find and
download Win-GRAF Workbench V11 from the “Software download” Tab.

P8
9 Ethernet Port (Workbench Port) Settings
Win-GRAF runtime (2.xx) or above version can set the Ethernet port.
Keep it as default 1100. After setting, click “Set” button and reboot Win-
GRAF Runtime to save the changes.