ICP DAS USA PCIe-LM4 User manual

P1
PCIe-LM4 Quick Start
v1.0, May. 2020
Packing List
In addition to this guide, the package includes the following items:
PCIe-LM4
Technical Support
[e-mail]
www.icpdas.com
Resources
How to search for drivers, manuals and
spec information on ICP DAS website.
For Mobile Web
For Desktop Web
Related Information
For more detailed information related to the software manual, hardware
manual, PCIe-LM4 Driver & SDK and sample program:
http://www.icpdas.com/en/download/index.php?model=PCIe-LM4
PCIe-LM4
PCIe-LM4

P2
1 Installing Windows Driver
1) Download or locate the Windows driver.

The PCIe-LM4 driver supports 32-/64-bit Windows
XP/2003/2008/7/8/10, which can be found in the
http://www.icpdas.com/en/download/show.php?num=2358&model=PCIe-LM4
2) Click the “Next>” button to start the installation.
3) Check your DAQ Card is or not on supported list, then click the
“Next>” button.
4) Select the installed folder, the default path is C:\ICPDAS\PCIe-LM4,
confirm and click the “Next>” button.
5) Check your DAQ Card on list, then click the “Next>” button.
6) Click the “Next>” button on the Select Additional Tasks window.
7) Click the “Next>” button on the Download Information window.
8) Select “No, I will restart my computer later” and then click the
“Finish” button.
NOTE:
For more detailed information related to driver installation, refer to
Chapter 4 “Starting” in the PCIe-LM4 user manual.

P3
2 Installing Hardware on PC
1) Power off the Computer.
2) Remove all covers from the Computer.
3) Select an unused PCI /PCI Express slot.
4) Carefully insert the Card into PCI/PCI
Express slot.
5) Replace the Computer Covers.
6) Power on the Computer.
7) The operating system will automatically detect the new hardware and
install the necessary drivers after reboot the PC.
8) Open the “Device Manager” to verify that the PIO-D64 Series Card
has been correctly installed and is in the Device Manager, as illustrated
on below.
PCIe-LM4 Motor Board

P4
3 Pin Assignments

P5

P6
4 Testing Board
Prepare for device
CA-MINI68-25 (optional) cable
DN-68A (optional) daughter board
Battery
1) Connect the CON1 to DN-68A board using the CA-MINI68A cable.
2) AI functional test and wiring
Connect the signal source to AI channel 4, and connect the signals as follows.
Connect the AI4+ pin (Pin14)on the terminal board to positive signal
terminal (+)
Connect the AI4- and AGND pin (Pin48,Pin47) on the terminal board to
negative signal terminal (-)

P7
3) Launch the PCIe-LM4_IO_DIAG program, it was installed in the
default folder, it will be located at “C:\ICPDAS\PCIe-LM4\Driver”.
4) Click the “Trigger”button to start the test.
Select the “0:15000Hz” from the “Rate”.
Click “Trigger”buttons.
5) Check the results of the Analog Input functions test.
Check the values is or not equal battery.



