iDataLink ADS-TBSL-GM User manual

VERSION FRANÇAISE DISPONIBLE EN LIGNE AU www.idatalink.com
PLEASE VISIT www.idatalink.com/support FOR COMPLETE PRODUCT DETAILS
Automotive Data Solutions Inc.
ADS-TBSL-GM
INSTALL GUIDE GM
The Pontiac, Chevrolet, Buick, Saturn, Saab, Oldsmobile, Isuzu, Hummer, GMC and Cadillac logos are
property of their respective owners. —© 2007 - Automotive Data Solutions Inc
VERSION FRANÇAISE DISPONIBLE EN LIGNE AU www.idatalink.com
PLEASE VISIT www.idatalink.com/support FOR COMPLETE PRODUCT DETAILS
Automotive Data Solutions Inc.
ADS-TBSL-GM
INSTALL GUIDE GM
Rev.Date:December24,2007
Doc.No.:##00160##

INSTALL GUIDE
Version française disponible en ligne au www.idatalink.com
Transponder Bypass
General motors
Page 2 of 6 ADS-TBSL-GM 20071220
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
VEHICLE COMPATIBILITY CHART
make model 98 99 00 01 02 03 04 05 06 07 type
BUICK
Allure 1 1 1 PK3
Century 1 1 1 1 1 1 VATS
Lacross 1 1 1 PK3
LeSabre / Ultra 111111 PK3
Park Avenue 1 1 1 1 1 1 1 1 PK3
Rainier 1 1 1 1 PL
Regal 1 1 1 1 1 VATS
Rendez-vous 111111PK3
Terraza 1 1 1 PK3
CADILLAC
CTS 1 1 1 1 1 PK3
Deville 1 1 1 1 1 PK3
Escallade 11111111 PL
Escallade EXT 1 1 1 1 PL
Seville 1 1 1 1 1 1 1 PK3
SLS 1 1 1 1 1 1 1 PK3
SRX 1 1 1 PK3
STS 1 1 1 1 1 1 1 PK3
CHEVROLET
Astro 1 1 1 1 1 1 1 1 PL
Avalanche 1 1 1 1 PL
Blazer 1 1 1 1 1 1 1 1 PL
Cavalier 111111 PL
Express 1111111111PL
Impala 111111 PL
Monte Carlo 111111 PL
S10 / S15 1 1 1 1 1 1 1 PL
Silverado 11111111 PL
SSR 1 1 1 PL
Suburban 11111111 PL
Tahoe 11111111 PL
Trailblazer 111111PL
Uplander 1 1 1 PK3
Venture 2 1 1 1 1 1 PK3
HUMMER H2 11111PL
GMC
Envoy 111111111PL
Jimmy 1 1 1 1 1 1 1 PL
Safari 1 1 1 1 1 1 1 1 PL
Savana 1111111111PL
Sierra/ CK 11111111 PL
Sonoma 1 1 1 1 1 1 1 PL
Yukon / Denali 11111111 PL
ISUZU Ascender 11111PL
Hombre 1 1 1 PL
OLDSMOBILE
Alero 1 1 1 1 1 1 PL
Aurora 1 1 1 PK3
Bravada 1 1 1 1 1 1 PL
Intrigue 1 1 1 PL
Silhouette 2 1 1 1 1 1 PK3
1. determine install type Refer to chart below
This product is protected
by one or more of the
following patents:
U.S. Letters Patent
No. 5,719,551
No. 6,011,460 B1*
No. 6,243,004 B1
No. 6,249,216 B1
No. 6,275,147 B1
No. 6,529,124 B2
No. 6,696,927 B2
No. 6,756,885 B1
No. 6,756,886 B2
No. 6,771,167 B1
No. 6,812,829 B1
Canadian Patent
No. 2,320,248
No. 2,415,023
No. 2,426,670
No. 2,415,041
No. 2,414,991
No. 2,415,038
European Patent
No. 1,053,128
note
Please advise that this data
module does not disarm
OEM alarm. For OEM alarm
arm/disarm application, we
recommend using the DLSL-GM,
GM1, GM2, GM3 or GM4 products
(see our website for compatibilty
charts).
Doc.No.:##00160##

www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
INSTALL GUIDE
Version française disponible en ligne au www.idatalink.com
Transponder Bypass
General motors
Page 3 of 6 ADS-TBSL-GM 20071220
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
VEHICLE COMPATIBILITY CHART
161514131211109
87
654321
BLUE/RED (NC)
BLUE/YELLOW (NC)
GREEN/RED (NC)
GREEN/YELLOW (NC)
GRAY/RED - DATA
GRAY/YELLOW (NC)
ORANGE - DATA (J1850)
PINK/BLACK (NC)
PINK - IGNITION INPUT
WHITE/BLACK (NC) WHITE/RED (NC) WHITE (NC)
RED - 12V
BLACK - GROUND
NO WIRE (NC)
BLUE/WHITE - GROUND-OUT WHEN RUNNING
CONNECT TO PIN #2 OF OBDII
CONNECTOR LOCATED UNDER
DRIVER SIDE DASHBOARD
IDATALINK
CONNECT EITHER
IDATALINK OR
STANDARD WIRING
LEGEND
Wiring connections not required
when installed in iDataLink mode
REMOTE
STARTER
IDATALINK (RS232) PORT
REQUIRED ON REMOTE STARTER.
IF UNAVAILABLE USE STANDARD WIRING METHOD
make model 98 99 00 01 02 03 04 05 06 07 type
PONTIAC
Aztek 1 1 1 1 1 PK3
Bonneville 111111 PK3
Grand Am 1111111 PL
Grand Prix 2222
Montana 2 1 1 1 1 1 PK3
Montana SV6 1 1 1 PK3
Sunfire 111111 PL
Transport 2
SAAB 97x 1 1 PL
SATURN Relay 1 1 1 PK3
S111111 PL
Type 1 WIRING DIAGRAM
2. proceed with installation See applicable wiring diagram
NOTE : ensure all connections are completed and properly secured prior to connectinG the wire harnesses to the module.
Doc.No.:##00160##

INSTALL GUIDE
Version française disponible en ligne au www.idatalink.com
Transponder Bypass
General motors
Page 4 of 6 ADS-TBSL-GM 20071220
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
Type 2 WIRING DIAGRAM
BLUE/RED (NC)
BLUE/YELLOW (NC)
GREEN/RED (NC)
GREEN/YELLOW (NC)
GRAY/RED - DATA OUT
GRAY/YELLOW (NC)
ORANGE (NC)
PINK/BLACK - IGNITION OUT IMMOBILIZER SIDE
PINK - IGNITION IN ECM SIDE
GRAY
ORANGE
PURPLE
BLACK
BLUE
PINK
WHITE/BLACK (NC) WHITE/RED (NC) WHITE (NC)
RED - 12V
BLACK - GROUND
NO WIRE (NC)
BLUE/WHITE - GROUND-OUT WHEN RUNNING
CONNECT EITHER
IDATALINK OR
STANDARD WIRING
IDATALINK
LEGEND
Wiring connections not required
when installed in iDataLink mode
REMOTE
STARTER
IDATALINK (RS232) PORT
REQUIRED ON REMOTE STARTER.
IF UNAVAILABLE USE STANDARD WIRING METHOD
PK3
PK3
PASSLOCK III
MODULE
Doc.No.:##00160##

www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
INSTALL GUIDE
Version française disponible en ligne au www.idatalink.com
Transponder Bypass
General motors
Page 5 of 6 ADS-TBSL-GM 20071220
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
12
Insert the vehicle key into the ignition.
Turn the ignition to the “ON” position and
START THE VEHICLE.
Wait for the LED to illuminate green
for 2 SECONDS.
Programming is complete.
VEHICLE PROGRAMMING
ON
LED “ON” 2 SEC
12
NOTE
MODE SELECTION
1X 2X
PRESS
TO TOGGLE
BETWEEN MODES PRESS + HOLD
Should you wish to change the installation mode,
follow the “Factory Reset” instructions as detailed below.
Press and release the programming button to select installation mode. To register selection,
Hold the programming button down
until the LED displays a solid green light.
OR
IDATALINK MODE STANDARD MODE
LED flashes once LED flashes twice
REMOTE STARTER
with Data Port
REMOTE STARTER
without Data Port
PROGRAMMING PROCEDURE
3. proGram your module See instructions below
Doc.No.:##00160##

INSTALL GUIDE
Version française disponible en ligne au www.idatalink.com
Transponder Bypass
General motors
Page 6 of 6 ADS-TBSL-GM 20071220
www.idatalink.com For technical assistance, contact your distributor or visit www.idatalink.com/support © 2007 ADS Inc.
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
GREEN
CORRECTLY
PROGRAMMED
RED
INCORRECTLY
PROGRAMMED
1
3 4
2
DIAGNOSTICS
FACTORY RESET PROCEDURE
HOLD
When the remote starter is engaged, the LED will flash green to indicate the module
has been correctly programmed. If the LED remains illuminated red, the device is
incorretly programmed.
Unplug all connectors from the module. Press and hold the programming button while inserting either
the 4-PIN standard or 4-PIN optional iDatalink connector.
The LED will begin to flash red. Immediately release the programming button.
The LED will turn on solid red for 2 seconds to confirm module reset.
Once reset is confirmed, plug in remaining connections and
REPEAT PROGRAMMING PROCEDURE
INSERT
4 PIN CONNECTOR
UNPLUG CONNECTORS
WHEN LED FLASHES RED
RELEASE THE BUTTON
SOLID RED LED
CONFIRMS FACTORY RESET
Doc.No.:##00160##