iLoq C10S User manual

User Manual
Lock Cylinder C10S/P
iLOQ
2.5.2013
Operation, Maintenance and Installation instructions for iLOQ Lock Cylinders C10S/P
[email protected]
www.stedaparts.nl

iLOQ Oy www.iLOQ.com [e-mail]
Table of content
Operation instructions..........................................................................................................2
Maintenance instructions .....................................................................................................2
Installation instructions........................................................................................................3
1
[email protected]
www.stedaparts.nl

iLOQ Oy www.iLOQ.com [e-mail]
Operation instructions
To operate the lock cylinder, insert the key entirely into the keyway and turn the key.
If the lock does not open, remove the key and reinsert it into the cylinder, this time more slowly.
Always insert the key into the cylinder gently and slowly. The electric energy is harvested when
the key is inserted into the cylinder. If the movement is too fast the cylinder is kept in the
locked state. Do not use force when inserting a key into the cylinder.
Warning
Do not insert anything else than the iLOQ Key K10S/P into the cylinder. The product should not
be modified in any way expect in accordance with those modifications described in the
instructions.
Maintenance instructions
Clean up and lubricate the cylinder at least once a year.
1. Apply high pressure dust remover into the keyway (for e.g., CRC Dust Off).
2. Apply a drop or two of high-quality lock oil into the keyway (for e.g., CRC Lock Oil Pro).
2
[email protected]
www.stedaparts.nl

iLOQ Oy www.iLOQ.com [e-mail]
Installation instructions
These instructions should be carefully followed during installation.
Use appropriate cylinder type according the installation environment: C10S.1 for outdoor use and
C10S.10 only for indoor use where temperature and humidity are equivalent to normal indoor
conditions.
Use Scandinavian oval cylinder compatible lock cases.
Install the cylinder according to the examples presented in the figures below. The
installation equipment and method may vary, depending on the used lock case type and
escutcheon. However, always pay attention to the followings:
Cylinder thread deepness is 7 mm. The maximum screw length is 6 mm. Usage of too long
screw may damage the cylinder.
Use reasonable force (2..3 Nm) when tightening the cylinder fixing screws.
3
[email protected]
www.stedaparts.nl

iLOQ Oy www.iLOQ.com [e-mail]
Align the cylinder front with the escutcheon front. Use appropriate height of the escutcheon
and/or adjust the cylinder height using an extension piece.
A cylinder extension piece iLOQ A10.33 must be used between the cylinder and the lock
case in case of the cylinder height adjustment is necessary. When using the extension piece,
also use appropriate longer tail piece.
4
[email protected]
www.stedaparts.nl

iLOQ Oy www.iLOQ.com [e-mail]
For high security purposes, use iLOQ escutcheons E10.D1, E10.D3, E10.E1, E10.E2 or E10.E8
to meet attack resistance grade 2 according standard EN15684.
In harsh environment where the cylinder is exposed to a dust or long term salt water spatter use a
weather cover such as iLOQ E10.D3 escutcheon with a lid.
When installing cylinders on the exit side, use appropriate exit hardware together with the cylinder
to allow free exit.
Care should be taken to ensure that any seals or weather-stripping fitted to the complete door
assembly, does not inhibit the correct operations of the cylinder.
Before fitting the cylinder to a fire/smoke resisting door, the fire certification should be examined,
to ensure conformity.
Care should be taken to ensure that no projection of the cylinder and associated parts, can
prevent the door swinging freely.
These instructions and any maintenance instructions should be passed on by the installer to the
user.
5
[email protected]
www.stedaparts.nl