Innova CO-48 User manual

0
New Brunswick Scientific
Innova® CO-4
8
Stacking Frame with Feet
P0628-5090
Assembly Instructions Revision A

1
Innova Co-48 - Base Stand Assembly Instructions
1) Remove components from packaging.
2) Identify Base Stand, Feet, M10 Lock - Nuts and Washers.
3) Assemble Lock - nuts and washers to feet, making sure that the nut is placed before
the washer (shown below).
4) Turn base face down and assemble feet (shown below) – do not fully tighten.
Base Stand x 1
Foot x 4
M10 Washer x 4
M10 Lock -
Nut x 4

2
5) Turn base right way up and place on feet.
6) Place the base stand in desired location and check that it is stable. If it is not stable
then adjust the height of the feet with a spanner until rock is eliminated.
7) With the help of a second person place a MiniGalaxy incubator onto base-stand
making sure that the feet are located in the embossed areas (shown below).
N.B. From hereon in this incubator will be referred to as the bottom incubator.
8) Adjust the height of the feet on the bottom incubator to ensure equipment is level.
Use a spirit level on the bottom shelf of the incubator if necessary.
A
djust height if
necessary

3
Top Stand Bracket Assembly Instructions
8) Identify Top Stand Bracket, M8x16 Button Head Screws, Anti-Slip rubber pads
(supplied with MiniGalaxy) and Hex Key.
9) Remove the black blanking plug from either side of the bottom incubator.
10) Using two of the M8x16 Button Head Screws, partially screw one into the
threaded hole on either side of the bottom incubator (shown below).
Top Stand
Bracket x 1
M8x16 Button
Head Screw x 6
Leave
5mm Gap
A
nti-Slip Pads x 4
Hex Key
5mm AF

4
12) Slide the Top Stand Bracket forward until the slots locate on the screws (shown
below).
13) Partially screw the remaining M8x16 Button Head Screws into the threaded holes
in the rear of the bottom incubator (shown below).
14) Fully tighten the four screws on the rear of the incubator followed by the sides.
M8x16 Button
Head Screw

5
15) Attach the 4-off Anti Slip pads to the feet of the top incubator.
16) With the help of a second person, place the remaining MiniGalaxy on the Top
Stand Bracket by sliding it in from the front (Shown Below).
17) Adjust the height of the feet on the top MiniGalaxy to prevent any rock on the
unit. Use a spirit level on the bottom shelf of the incubator if necessary.
Slide Incubator
In This Direction

6
Specifications
Innova CO-48 Stacked Dimensions
All dimensions in mm
Stacking System - Shipping Weights and Dimensions
Packaged Dimensions WxDxH (mm): 530x540x350
Packaged Weight: 15kg
Volumetric Weight: 17kg