Intermec CK30 User manual

CK30 and CK31 Handle Instructions
*943-079-001*
P/N 943-079-001 CK30 and CK31 Handle
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax[phone]
www.intermec.com
©
2006 Intermec Technologies
Corporation. All rights reserved.
Toclean the handle
Remove the handle screwand take
the handle off the CK30 or CK31.
Use a damp clothto clean the
bottomsurface of the computer
and the mountingsurface on the
handle.
Press and hold the trigger to
expose the magnet.Use adhesive
tape to remove any metal shavings
fromthe magnet surface.
3
2
1
Magnet
Instructions
Cleaning the Handle

Use these instructions to install the handle on a CK30 or CK31 Handheld Computer.
Toinstall the handle
(CK31 only) Remove the adhesive backing
fromthe spacer.
(CK31 only) Insert the spacer on the
CK31 handle and press to make sure it is
securely attached.
1
Donot overtighten the handle screw.
You may damage the threadsor cause
the triggermechanism to jam.
2
Installing the Handle
Place the handle on the computer.
Tighten the screwso the handle does not move.
If you have a torque screwdriver,tighten the screwto
1.26 Nm(12in-lb) maximum.
3
4
Spacer
Installing the Handle (continued)
Installing the Handle