Intermec IP3 Intellitag User manual

IP3/IP4 Lightpipe Kit Instructions
The Lightpipe improves the IrDA communication reliability and
speed between your reader and the mobile device. This kit
includes the following contents:
• IP3/IP4 Reader Lightpipe with pre-applied adhesive
• IP3/IP4 Reader Lightpipe Instructions
Reader and Mobile Device Surface Preparation
1Remove the existing gold reflector tape from your Reader. It is
recommended that you use rubbing alcohol to remove any
remaining reflector tape residue. However, do not use any sol-
vent remover that will harm the Reader plastic.
2Remove the existing IR Reflector label on your mobile device
(if applicable). Ensure all label residue is removed from that
location.
Reader gold
reflector tape
Mobile device
reflector label

Lightpipe Installation
1Remove the backing from the adhesive on the Lightpipe
assembly.
2Position the lower end of the Lightpipe into the angled recess
of the Reader.
3Align the upper end with the molded feature in the Reader so
that the edge of the Lightpipe fits squarely across the edge of
the molded feature.
4Press firmly into place and hold for a few seconds to allow the
adhesive to set.
Note: It is very important that the new Lightpipe is
positioned exactly as shown in the following illustra-
tion. This helps ensure proper reflecting of the Infrared
signals between your mobile device and your reader.
Adhesive backing
Lightpipe in proper
position
Molded feature
8PSMEXJEF)FBERVBSUFST
UI"WFOVF8FTU
&WFSFUU8BTIJOHUPO64"
UFM 
XXXJOUFSNFDDPN
ª*OUFSNFD5FDIOPMPHJFT
$PSQPSBUJPO"MMSJHIUTSFTFSWFE
*1*13FBEFS-JHIUQJQF*OTUSVDUJPOT

1/





