Intermec Oracle-Ready CK31 User manual

CK31 Tethered Stylus Instructions
Attach a CK31 tethered stylus to your CK31 Handheld Computer
to make sure you can always find your stylus. The tethered stylus
installs easily on the back of the CK31 with a single screw.
Unpacking the Tethered Stylus
The tethered stylus comes in a plastic bag with this instruction
sheet and these items:
Screw
Tethered
stylus Retaining
bar
Installing the Tethered Stylus
Follow these instructions to install the tethered stylus on the CK31.
You will need a small Phillips screwdriver.
To install the tethered stylus
1Secure the retaining bar to the back of the CK31 with the screw.
Retaining
bar

6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©2005 Intermec Technologies
Corporation. All rights reserved.
CK31 Tethered Stylus Instructions
*075444-001*
P/N 075444-001
2Thread the loop on the end of the stylus assembly under the
retaining bar.
3Insert the stylus through the loop and tighten the small loop.
4Insert the stylus into the holder on the CK31.
Insert stylus
into holder