Intermec EasyCoder F4 User manual

1
Intermec EasyCoder F4
EasySet Bar Code Wand Setup
1. Connect the EasySet bar code wand to the
receptacle on the printer’s rear plate. 2. Readtheappropriatebarcodetosetuptheprin- ter. Hold the wand like a pencil and move it
rather swiftly across the bar code.
3. When the bar code has been accepted, the prin-
ter emits a short beep and the Ready control
lamp on the printer’s front blinks briefly.
4. This sheet only contains a selection of setup
options.Forinformationonhowtoproduceyour
own setup bar codes, please refer to the Inter-
mec Fingerprint 7.2 Reference Manual.
Serial Communication on ”uart1:”
Baudrate
1-960480-00 EasySet Bar Code Sheet for EasyCoder F4Edition 1, October 1999
Connect here!

2
Serial Communication on ”uart1:”, cont’d.
No. of Stop Bits
RTS/CTS
ENQ/ACK
XON/XOFF, Data to Host
Reset comm. to default
Parity
Char. Length

3
Peel Off
Start- and Stopadjust
Tear Off
Media
Contrast
XON/XOFF, Data from Host
New Line
Serial Communication on ”uart1:”, cont’d.
Default

4
Media, cont’d.
Media Width
Media Length

5
Media, cont’d.
Print Speed
Test Labels
Media Type

6
Direct Thermal Printing (Europe)
Paper Type
Direct Thermal Printing (USA)