Intermec PW50 User manual

Vehicle Mount
Guide d’installation du socle de véhicule
Installationsanleitung für Fahrzeugbefestigung
Guia de Instalação do Suporte do Veículo
Инструкция по установке автомобильной стойки
Guía de instalación del montaje para vehículos
PW50
Installation
Guide

ii
Contents
PW50 Vehicle Mount Installation Guide . . . . . . . . . . . . . . . 3
Guide d’installation du socle de véhicule PW50 . . . . . . . . 13
Installationsanleitung für Fahrzeugbefestigung PW50. . 23
Guia de Instalação do Suporte do Veículo PW50 . . . . . . . 33
Инструкция по установке автомобильной стойки PW50. 43
Guía de instalación del montaje para vehículos PW50 . . 53

3
PW50 Vehicle Mount Installation Guide
The PW50 Vehicle Mount (Model AV11) provides you with a
convenient way to mount the PW50 Workboard Printer to your
vehicle for charging or printing. This installation guide describes
how to install these vehicle mounts:
•PW50 vehicle mount for the CN3 (P/N 225-749-xxx)
•PW50 vehicle mount for the CN3e (P/N 225-750-xxx)
•PW50 vehicle mount for the CK61 (P/N 225-751-xxx)
The procedures are the same for each vehicle mount. However,
for convenience, the CN3 version is shown in the illustrations.
The shipping box for the vehicle mount contains these items:
PW50 Vehicle Mount Shipping Box Contents
Note: The PW50 vehicle mount is not recommended for use
with the CK61ex.
RAM
vehicle base
RAM vehicle
mount base
Mounting
arm
Vehicle mount
Documentation
Hardware

4
Items Not Provided
•Power cord. You need to purchase the appropriate power
cord separately. For help, contact your Intermec sales
representative.
•Common hand tools.
•Electric drill and drill bits.
Installing the Vehicle Mount
1Use the four hex screws and the hex key to attach the RAM
vehicle mount base to the vehicle mount.
2Use the four 1/4-inch-flathead hex screws and nuts to attach
the RAM vehicle base to your vehicle.
Vehicle
mount
RAM vehicle
mount base
Hex screw
(4 places)

5
3Place the mounting arm over the two bases, and then tighten
the mounting arm.
4Remove the two screws from the connector cover on the back
of the PW50.
Vehicle
mount
RAM vehicle
mount base Mounting arm
RAM
vehicle base